In the preparation of the surface, the ordinary hand tools, or spades and shovels, may be used. If, however, the soil is mellow, a fork is a better tool than a spade, from the fact that it does not slice the soil, but tends to break it up into smaller and more irregular masses. The ordinary spading-fork, with strong flat tines, is a most serviceable tool; a spading-fork for soft ground may be made from an old manure fork by cutting down the tines, as shown in Fig. 84.
It is important that the soil should not be sticky when it is prepared, as it is likely to become hard and baked and the physical condition be greatly injured. However, land that is too wet for the reception of seeds may still be thrown up loose with a spade or fork and allowed to dry, and after two or three days the surface preparation may be completed with the hoe and the rake. In ordinary soils the hoe is the tool to follow the spading-fork or the spade, but for the final preparation of the surface a steel garden-rake is the ideal implement.
In areas, large enough to admit horse tools, the land can be fitted more economically by means of the various types of plows, harrows, and cultivators that are to be had of any dealer in agricultural implements. Figure 85 shows various types of model surface plows. The one shown at the upper left-hand is considered by Roberts, in his “Fertility of the Land,” to be the ideal general-purpose plow, as respects shape and method of construction.
The type of machine to be used must be determined wholly by the character of the land and the purposes for which it is to be fitted. Lands that are hard and cloddy may be reduced by the use of the disk or Acme harrows, shown in Fig. 86; but those that are friable and mellow may not need such heavy and vigorous tools. On these mellower lands, the spring-tooth harrow, types of which are shown in Fig. 87, may follow the plow. On very hard lands, these spring-tooth harrows may follow the disk and Acme types. The final preparation of the land is accomplished by light implements of the pattern shown in Fig. 88. These spike-tooth smoothing-harrows do for the field what the hand-rake does for the garden-bed.
If it is desired to put a very fine finish on the surface of the ground by means of horse tools, implements like the Breed or Wiard weeder may be used. These are constructed on the principle of a spring-tooth horse hay-rake, and are most excellent, not only for fitting loose land for ordinary seeding, but also for subsequent tillage.
