“The handles of Mrs. Tarryer’s hoes are never perfectly straight. All the bayonet class bend downward in use half an inch or more; all the thrust-hoe handles bend up in a regular curve (like a fiddle-bow turned over) two or three inches. Unless they are hung right, these hoes are very awkward things. When perfectly fit for one, they may not fit another; that is, a tall, keen-sighted person cannot use the hoe that is just fit for a very short one.... Curves in the handles throw centers of gravity where they belong. Good timber generally warps in a handle about right, only implement makers and babes in weeding may not know when it is made fast right side up in the hoe.
“There are plenty of thrust-hoes in market, such as they are. Some have malleable iron sockets and bows—heavier to the buyer and cheaper to the dealer—instead of wrought-iron and steel, such as is required for true worth.”
For many purposes, tools that scrape or scarify the surface are preferable to hoes that dig up the ground. Weeds may be kept down by cutting them off, as in walks and often in flower-beds, rather than by rooting them out. Figure 98 shows such a tool, and a home-made implement answering the same purpose is illustrated in Fig. 99. This latter tool is easily made from strong band-iron. Another type is suggested in Fig. 100, representing a slicing-hoe made by fastening a sheet of good metal to the tines of a broken fork. The kind chiefly in the market is shown in Fig. 101.
