While this table may be made in various sizes, the one shown in the accompanying drawing has proven very popular.
The four legs are first made 7/8" × 1-1/4" × 12". Measure down 3" from one end and taper the legs equally from this point to a width of 7/8" at the opposite ends, as shown.
The two side rails are made 1/2" × 2-7/8" × 6-1/2". The two front rails above and below the drawer are cut 1/2" × 1/2" × 12".
On the side and rear rails, centers for dowels are located 5/8" from the top and lower edges and half way between the sides. An inch brad is driven in a short distance at these points, and the head is cut off about 1/4" above the surface of the wood. These ends are now placed so that their upper edges are even with the top of the legs. Press down lightly on the rails and a mark will be made on the surface of the legs.
Remove the brads and bore the dowel hole with a 1/4" bit, 1-1/4" deep.
The two drawer rails are treated in the same manner and the holes are bored.
The top will no doubt have to be made of two pieces of wood jointed and glued together, and reinforced with dowels.
The finished dimensions are 3/8" × 12" × 19".
Short blocks of wood are screwed to the rear and two side rails even with their tops, and screws are later put through these from their under side to hold the top in place. A 3/4" No. 6 screw is placed in the center of the upper drawer rail to assist in holding the top in place. (See [Plate 28] for details of the method of attaching the top.)
Two strips of wood 1/2" wide, and thick and long enough to fit tightly between the front and rear rails, are made to serve as drawer slides.