Follow directions on the last plate for making rockers, base and footboard.
The headboard is cut 1/2" × 8-3/4" × 10-7/8".
Place a center line, longways of the piece, as shown in the end view. At the top measure 1-1/4" each side of the center line and make a dot. At the base measure 3-3/8" each side of the center line and place a dot.
Measure 1-3/4" from the top edge, on each side. Connect these points, as shown in the end view. Cut carefully to the lines. Test the head and footboard to see if they compare.
Make the two sides of the cradle next 1/2" × 9-1/4" × 20".
Seven inches from one end and 6-1/4" from the lower edge strike a circle 1-3/8" in radius. From the lower edge of this circle draw a line parallel to the base. This will make the narrow part of the sides 4-1/2" wide.
From the point directly over the center of the circle, square a line to the top edge of the side. The outline of the side is now ready to be cut out. If an expansive bit is obtainable, bore the hole from the center of the circle with the bit set at 1-3/8" radius. If this bit is not obtainable, the hole must be cut out with a key-hole or a turning saw after first cutting to the circle, along the other lines previously drawn.
The short top edge of the sides should now be beveled to conform to the slope of the head board.
Next make the two top pieces which form the sloping part of the roof. These are 1/2" × 5-1/4" × 7-3/4". These must be planed at their top edge to quite a sharp bevel until they are even with the top of the head board.
The top piece is the final piece cut, and this is 1/2" × 4-3/4" × 7-3/4".