The bottom piece is made 1/2" × 6" × 6-1/2".
Plate 42.
The piece to which the wheels are attached, is made 7/8" × 1" × 7-1/8". This piece has two holes bored and countersunk in it for screws, 1-1/4" from the ends and half way between the sides.
Two small blocks are made 1/2" × 1" × 2-1/2" and tapered 3/4", as shown. These blocks have holes bored and countersunk for screws. Bore the holes in such a manner that they will not come directly opposite each other, otherwise the screws will be likely to hit each other.
Holes are bored in the front piece of the cart and countersunk on the inner side. These pieces are 3" from either side, the first one being 2-1/4" from the upper edge and the second an inch below the first.
The handle measures 7/8" × 1" × 30". A hole is bored 5/8" from the front end with a half-inch bit and the extreme end of the handle is slightly chamfered for a finish. The opposite end of the handle is cut at an angle of 30°, as shown.
A piece of dowel, 1/2" in diameter and 3" long, is cut and inserted in the hole in the handle and secured by driving an inch brad in from the under side of the handle.