Plate 43.
The two sides are first made 1/2" × 5-1/2" × 12", and the two ends 1/2" × 6" × 7-1/2". The sides are beveled about 1/8" on the lower edge so that they will conform to the angle of the end piece. The ends taper from 7-1/2" long at the top to 5-5/8" at the bottom. This angle is obtained by measuring in 15/16" from either side and drawing to the opposite upper corner. Saw and finish to this line and slightly round the upper corners, as shown. Bore a hole with a 1/2" bit at the point indicated.
The bottom piece is made 1/2" × 6-5/8" × 12".
Sand these five pieces and assemble, using 1-1/4" brads and glue. Plane the side edges of the bottom board to the same angle as the slope of the sides.
The two end uprights are now made 1/2" × 6-3/4" × 8". Measure up 2-1/4" on the short edges and place a dot. Connect these points with a sloping line and saw and finish to the outline shown. Bore holes with a 1/2" bit at the place indicated. Locate and bore a screw hole 1/2" up from the center of the lower edge to attach brace block.
Make two small supporting blocks 7/8" × 1-3/4" × 1-3/4". Bore a 1/2" hole carefully in the center and drill four smaller holes to receive 1-1/4" No. 8 flat-head screws, 3/8" from each other, as shown. Countersink these four holes.
Glue and screw these blocks to the end of the wagon box, 1-1/4" from the top edge, as shown.
Make two brace blocks by first cutting out a square 7/8" × 1" × 1" and cutting this in two diagonally from corner to corner. Glue and screw these blocks to the end uprights, using 1" No. 6 flat-head screws.