Fasten one wheel brace in its proper place with 1" No. 6 flat-head screws from the upper side of the bottom board.
Place the axle of the wheel in the hole and attach the other wheel in the same manner.
Glue and screw the front uprights in place, as indicated, with 1" No. 6 round-head screws, and place the top cross piece on these and hold in place with glue and 1" round-head blue screws.
Place the sides in position, with the front ends flush with the outer edges of the front braces. Place the metal braces over the supporting pieces and screw in place, using 1" No. 6 round-head blue screws.
Braces X, which run from the wheel supports to the front piece of the wheelbarrow, are screwed in place, as shown, using 1-1/4" No. 8 round-head screws.
It will be noticed that the hole for the dowel stick in the leg only extends in 3/8". Place one leg in position, 14-1/2" from the ends of the handles, using glue and 1" No. 6 round-head blue screws. Insert the dowel stick in this leg and also in the second leg and secure the second leg in place. The dowel should have glue placed on its ends, and, after the legs are in place, an inch brad should be driven into each leg, through the dowel, to hold it firmly in place.
The color scheme given in the drawing is a pleasing one. The wheel is painted two coats of red before being placed in position.