Original Design—Marine Picture Frame.
For the benefit of those who spend their summers at the sea-shore where such things are obtainable, I would advise that a small collection be made of the quaint and pretty products of the place, as they will be found useful in various ways for decorative purposes.
Fig. 190.—Section of Decorated Frame
The next sketch (Fig. 190) shows a corner section of frame especially appropriate for a flower piece. The open lattice-like border is cut with a sharp penknife from stiff pasteboard and tacked along the edge of the frame.
The pattern shown in diagram (Fig. 191) is simple, quite easily made, and well suited for a border, though other and more elaborate ones may be used. This border must, of course, be made in sections. The edges to be connected should be cut to fit exactly, then after tacking them upon the frame the whole may be laid upon a table, face downward, and strips of paper pasted across the joints (see Fig. 192), which will hold them securely together. If the work is neatly done, when the gilt is applied all traces of the joints will disappear. The decorations of this frame consist of a spray of artificial rosebuds and leaves, gilded and tacked on the upper left-hand corner. A few scattered rosebuds look well upon the lower part of the frame near the right-hand side.
Section of Border for Decorated Frame.
Figure 193 is the section of a frame which will look well on almost any kind of picture. It is made by tacking a small rope around the inside edge and then covering it and the frame with crumpled tin-foil, which, after it is pressed to fit the rope, is brought around and tacked on the wrong side of the frame, joining that edge which is turned over the top. Care should be taken while handling the tin-foil not to flatten it, as its beauty depends upon its roughness. The pieces are joined by simply lapping one edge over the other, the uneven surface hiding all seams. This frame like the others must be gilded.