"Almost the whole of its surface is occupied. In the centre is a basin presenting an oval surface 25 inches the long way, and 12 inches the narrow way. The stone, which has been considerably worn away in consequence of long use, has been rubbed off to a central depth of about 1 inch; this portion must have been used for rubbing the larger objects after they had been roughly shaped by chipping. The length of the basin allowed a motion of considerable length to be given to the stone which was being worked, at the same time giving facilities to the workman for the exercise of all his strength. Added to this, this cavity enabled the almond-like shape to be given to the objects—a form which they nearly all present.
"Either in front or to the right, according to the position in which the observer stands, and almost touching the edge of this basin, there is a hole deeply hollowed in the stone, being 30 inches long; it extends along almost the whole length of the sandstone, with the maximum breadth of about 1 inch, and presents the shape of a very elongated spindle hollowed out to a depth of something less than half an inch in the centre, which tapers off to nothing at the two ends.
"The wear of the stone and the shape of this groove point out its intention. It must have been used to reduce the edges or the sides of the hatchet, which after the chipping and flat polishing were left either too thick or too sharp for a handle to be easily fitted to them. Added to this, it smoothed down the roughnesses caused by chipping, which it replaced by a round form of no great thickness, which was again and again rubbed flatly on the stone to give it a square and sharp-edged level. This last operation took place in a basin, and it gave to the hatchet a curve in a lengthwise direction which is by no means ungraceful.
"The thinning off of the edges of the groove was not an immaterial matter. It not only assisted in forming the above-named curve, but also prevented the cutting edge being distorted, and avoided the need of subsequent repolishing, which spoiled the object by rubbing it away too much.
"It must not be for a moment imagined that the edge of the hatchet was made in this groove. Examination proves the contrary, and that it was done flatwise while polishing the rest of the object; and if sometimes its thickness did not allow this, it was preliminarily done, and then finished in the general polishing.
"But although this basin, and its accompanying groove, on account of their dimensions, acted very well for polishing the large hatchets, the case was different with the smaller ones. This is the reason why two other smaller basins, and also a small groove, were made on the flat part of the stone by the side of the others.
"These two basins were placed at two corners of the face of the stone, but still parallel to the larger basin and also to the larger groove, so as to be convenient for the requirements of the workman engaged in polishing without compelling him to shift his position; one is 10 inches, and the other 13 inches in length, with a mean breadth of about 2½ inches. They are both in the shape of a rather narrow almond, and end almost in a point, which seems to show that they also were used in polishing somewhat narrow objects—perhaps to set right the edges of hatchets, in which the rubbing in the larger basin had produced cavities prejudicial to the perfection of the faces.
"The small groove, placed very near the larger one, is 9 inches long. It is the same shape as the other, but is not so deep, and scarcely half an inch wide.
"Not far from the end of this latter groove, at the point where it approaches the larger one, there are traces of a groove scarcely commenced.