A short time after, I attended, on a cold day, with a sharp saw, square, &c. I found his hives fourteen inches square inside, and eighteen deep, holding about 3,500 inches. Of this square, a little more than ten inches in height, would make just the right size. To work convenient, I inverted the hive on a barrel, set on end, marked the length, and sawed it off, without a bee leaving. It was very cold, (mercury at 6 deg.) The bees came to the edges of the combs, but the cold drove them back. In a short time I had taken off six; four when done were just about full; the other two were so when I began, but they were marked and sawed like the rest; when the combs were attached, they were severed with a knife, and the piece of the hive thus loose, was raised off, leaving several inches of the combs projecting out of the hive. I now cut off the first comb, even with the bottom of the hive. On the next comb there were a few bees; with a quill these were brushed down into the hive; this piece was then removed, and the bees on the other side of it were brushed down also. In this way all others were removed, and left the hive just full. The other full hive, after it was sawed on each side, a small wire was drawn through, parallel with the sheets, and severed all the combs at once; each piece was taken out, and the bees that were clustered on them brushed back; removing the loose part of the hive, was the last thing to be done. This last method was preferred to the other by my employer; yet it was all performed to his satisfaction, no sting or other difficulty about it, except the trouble of warming fingers rather frequently. Tobacco smoke would have kept them quiet during the operation, nearly as well. If preferred, a hive may stand right side up while sawing it.
MODERATE WEATHER BEST TO REMOVE BEES.
In transporting your bees, avoid if possible the two extremes of very cold, or very warm weather. In the latter the combs are so nearly melted, that the weight of the honey will bend them, bursting the cells, spilling the honey, and besmearing the bees. In very cold weather, the combs are brittle, and easily detached from the sides of the hive. When necessitated to move them in very cold weather, they should be put up an hour or so before starting. The agitation of the bees after being disturbed will create considerable heat; a portion of this will be imparted to the combs, and add to their strength.
PREPARATIONS FOR TRANSPORTING BEES.
To prepare for moving them, pieces of thin muslin about half a yard square is as good as anything, secured by carpet tacks.
SECURING BEES IN THE HIVE.
The hive is inverted, and the cloth put over, neatly folded, and fastened with a tack at the corners, and another in the middle. The tack is crowed in about two-thirds of its length, it then presents the head convenient to pull out. If the bees are to go a great distance, and require to be shut up several days, the muslin will be hardly sufficient, as they would probably bite their way out. Something more substantial would then be required. Take a board the size of the bottom, cut out a place in the middle, and cover with wire cloth, (like the one recommended for hiving,) and fasten it with tacks. This board is to be nailed on the hive. After the nails are driven, with the hammer start it off about the eighth of an inch; it will admit a little air around the sides as well as the middle, quite necessary for heavy stocks. But very small families might be safe without the wire cloth; air enough would pass between the hive and board, except in warm weather. New combs break easier than old.
BEST CONVEYANCE.
Probably the best conveyance is a wagon with elliptic springs. But a wagon without springs is bad, especially for young stocks. Yet I have known them moved safely in this way, but it required some care in packing with hay, or straw, under and around them, and careful driving. Good sleighing will answer very well, and by some thought to be the best time.
HIVE TO BE INVERTED.