Omit 17 and 18.
18a. Base Plate, Foundation, etc. Provide suitable base plate to rigidly support the exhauster and its motor as a unit, which shall be large enough to catch all drip of water or oil. Provide a raised margin and pads for feet of exhauster frame, motor, and anchor bolts, high enough to prevent any drip from getting into the foundation or on the floor.
18b. Provide suitable foundation of brick or concrete, to which base plate shall be firmly anchored. The foundation shall be built on top of the cement floor of the basement, which shall be picked to afford proper bond for the foundation.
18c. Construct the foundation of such a height as to bring the working parts of the machine at the most convenient level for operating purposes. Exposed parts of the foundation to be faced with best grade white enameled brick. If the base plate does not cover the foundation, the exposed top surface is to be finished with enameled brick, using bull-nose brick on all edges and corners.
19 to 23. Same as for Class 1.
23a. The guaranteed efficiency of motor shall not be less than 80% at half load and not less than 85% at full load.
24 to 32. Same as for Class 1.
32a. Motor shall be subject to shop test to determine efficiency, heating, insulation, etc. Manufacturers’ certified test sheets of motor, giving all readings taken during shop test, together with calculated results, must be submitted to the Architect for approval before motor is shipped from factory.
33. Rheostat. Furnish and install where shown, upon a slate panel hereinafter specified, a starting rheostat of proper size and approved make, designed for the particular duty it has to perform. It must have an automatic no-voltage and overload release. All resistance for rheostat is to be placed on the back of the tablet. Contacts must project through board to front side. All moving parts must be on front of board.
33a. Tablet. Furnish and place where shown, a slate tablet, not less than ³⁄₄ in. thick, supported by a substantial angle bar frame, so placed that there will be a space of not less than 4 in. between the wall and back of resistance. Mount on this tablet one double-pole, 250-volt knife switch, with two 250-volt inclosed fuses and one starting rheostat, as specified hereinbefore. The connections shall be on the back of the tablet. The space between the column and the tablet shall be inclosed with a removable diamond-mesh grill of No. 10 iron wire in channel frame.