The long piece which joins the two bases, marked 3, is 3 feet long (including joints), 3 inches wide and 2 inches high.
The large uprights marked 4 are 1 foot 6 inches long including joints, 2 inches wide, and 3 inches deep. They are fixed on the back base 9 inches apart. The holes in which the axle rests are made 2 inches below the top. These holes contain bearings of thin iron plates to secure easy motion of the axle. The bearings are kept open at the top to allow access of oil through a slanting hole bored on the outward sides of both the uprights, one inch above the axle.
The small uprights marked 5 are 9 inches long with joints 1½ inches wide and 1½ inches deep, with holes 4 inches below the top to contain the leather bearings which bear the spindle. They are fixed 3 inches apart on the front base and are connected together 2 inches above the base with a piece of a wood of the same thickness. This joining piece contains in the middle 2 sticks half an inch apart to regulate the position of the mala (the string which revolves the spindle) on the spindle.
Another piece marked 6 and joined parallelly to the left upright is meant to bear a hole for leather bearing when a thin spindle is to be used.
The drum or wheel consists of 8 planks such as the one marked 7, each being 2 feet long, 4 inches wide and ¾ inch thick. They are divided in two wings of 4 planks each, each containing two couples of planks joined diametrically with a groove in the middle.
Both the wings are nailed on to the wooden shaft marked 8, its size being 4½ inches long and 4 inches diameter.
Through the middle of this shaft passes a long round iron bar, which serves as an axle. It is 19 inches long and half an inch thick. Its end, where the handle is fixed is made square to ensure firmness of the handle.
A wooden washer one inch thick is fixed to the axle on either side of the drum to avoid its contact with the uprights.
The handle is shaped put of a wooden piece of 2 inches × 2 inches × 1½ feet long.
The reel noticed in the diagram between the drum and the handle is composed of a wooden disc marked 9 made out of 1 inch thick and 6 inches square piece of wood. Six brackets made of galvanized wire of 10 gauge radiate from the centre of the disc so as to make a circumference of 4 feet. The brackets are fixed in the back of the disc with bent ends and are further secured with small nails near the circumference of the disc.