Miss Parloa's New Cook Book

by Maria Parloa

To Lard.

Larding is a simple operation. The pork should be firm and young (salt, of course). Cut thin, even slices parallel with the rind, and cut these in long, narrow strips that will fit into the needle. For beef, veal, turkey or chicken the strips should be about as large round as a lead pencil, and about three and a half inches long; and for birds, chops, and sweetbreads they should be about as large round as a match. Three slices are all that can be cut from one piece of pork, because when you get more than an inch away from the rind, the pork is so tender that it will break when in the needle.

Put the strips in a bowl of broken ice, to harden. Have the meat, if beef or veal, free of skin and gristle. Put a strip (also called a lardoon) into the needle as far as it will go. With a skewer or knife draw a line on both sides of the meat and along the upper part. Thrust the needle into the meat at one of the side lines; and when it is about half way through to the top of the piece, press the steel slightly with the thumb and fore-finger, to hold the lardoon in place until it has entered the meat. Now push the needle through to the top, and gently draw it out, leaving about three-quarters of an inch of the strip exposed at both the side and upper part of the meat That part of the pork which is hidden should be half an inch under the surface. The needle's course is as if it started under the eaves of a gable roof and came out at the ridge-pole. Continue until all the rows are filled with lardoons. Two rows are enough for a fillet of beef. If the strips are too large for the needle they will be pressed out as soon as the lower part of the needle enters the meat.

To Stew.

The meat and vegetables for stews should, when it is possible, be browned in a little fat, and hot water should then be added. As soon as the stew comes to the boiling point, skim it, and set back where it will just simmer, not boil, the given time. The pieces of meat in a stew should come to the table whole and tender and juicy, and they will be in this condition only with slow cooking.

To Braise.

Braising is one of the best modes of preparing meat. There are pans expressly for braising; but any deep tin, sheet-iron, or granite-ware pan, with a cover, will answer quite well. The meat to be cooked must always be browned in some kind of fat, the vegetables fried in the same fat, and enough stock (if possible) or water be added to half cover the meat. The pan should then be covered and placed in the oven. The meat must cook slowly and thoroughly, and be basted frequently. No matter how tough, if properly braised it will become tender and juicy. If, however, the cooking is hurried the dish will be spoiled.

To Fry.

There are two modes of frying. One is to have just enough fat to prevent the article from burning or sticking; and the other is to have enough not only to cover the food, but to float it. The latter is by far the better way, as all the surface of the article is instantly hardened, and, therefore, will not absorb fat. It is also the cheaper way, because the fat can be used so many times. If the drippings saved from meats, soups and gravies should not be enough for frying purposes, buy pure lard to use with it. Many recommend buying beef suet for this same purpose; but food fried in suet is more liable to absorb fat than that fried in lard. The reason of this is that lard can be heated to a higher temperature without burning than can beef or any of the other fats. Butter is also often recommended for frying. If used, it should be free of salt. But aside from being so expensive, it is not so nice for frying purposes as fats, for it burns at a much lower temperature than either beef fat or lard. The Scotch kettle is the best utensil for frying. It rests on a rim, which lifts the bottom from the stove, and the inside surface is polished very smooth; therefore, the fat is less liable to burn than if the surface were rough and the bottom rested on the hot stove. The fat should heat gradually; and when the food is plunged into it a slight smoke should rise from the centre. It will smoke at the sides some time before it has become hot enough for frying. After the food has been put in, let the kettle stand on the hottest part of the stove until it regains its former temperature, and then set it back where it is not quite so hot. In frying fish-balls, doughnuts, etc., put only a few at a time in the boiling fat; then wait a few moments for the fat to regain its former temperature, and put in a few more. Fish-balls are often spoiled by the putting of a great many in the kettle at once. The temperature of the fat is instantly reduced, and the balls absorb the fat. When an article of food is fried, drain the fat from it, and lay it on a sheet of brown paper in a warm pan. The paper will absorb any fat that may remain on the food. As soon as you are through frying, take the fat from the fire, and when cooled a little, strain it, (See the chapter on the Care of Food.) If the directions given are followed, there will be no difficulty in having food fried without its being saturated with grease.

To Serve.