By the introduction of metallic salts into the carbons the possibilities of the arc-lamp were greatly extended. The luminous output of such lamps is much greater than that of an ordinary carbon arc using the same amount of electrical energy. Furthermore, the color or spectral character of the light may be varied through a wide range by the use of various salts. For example, if carbons are impregnated with calcium fluoride, the arc-flame when examined by means of a spectroscope will be seen to contain the characteristic spectrum of calcium, namely, some green, orange, and red rays. These combine to give to this arc a very yellow color. As explained in a previous chapter, the salts for this purpose may be wisely chosen from a knowledge of their fundamental or characteristic flame-spectra.
These lamps have been developed to meet a variety of needs and their luminous efficiencies range from 20 to 40 lumens per watt, being several times that of the ordinary carbon open-arc. The red flame-arc owes its color chiefly to strontium, whose characteristic visible spectrum consists chiefly of red and yellow rays. Barium gives to the arc a fairly white color. The yellow and so-called white flame-arcs have been most commonly used. Flame-arcs have been produced which are close to daylight in color, and powerful blue-white flame-arcs have satisfied the needs of various chemical industries and photographic processes. These arcs are generally operated in a space where the air-supply is restricted similar to the enclosed-arc principle. Inasmuch as poisonous fumes are emitted in large quantities from some flame-arcs, they are not used indoors without rather generous ventilation. In fact, the flame-arcs are such powerful light-sources that they are almost entirely used outdoors or in very large interiors especially of the type of open factory buildings. They are made for both direct and alternating current and the mechanisms have been of several types. The electrodes are consumed rather rapidly so they are made as long as possible. In one type of arc, the carbons are both fed downward, their lower ends forming a narrow V with the arc-flame between their tips. Under these conditions the arc tends to travel vertically and finally to "stretch" itself to extinction. However, the arc is kept in place by means of a magnet above it which repels the arc and holds it at the ends of the carbons.
The chief objection to the early flame-arcs was the necessity for frequent renewal of the carbons. This was overcome to a large extent in the Jandus regenerative lamp in which the arc operates in a glass enclosure surrounded by an opal globe. However, in addition to the inner glass enclosure, two cooling chambers of metal are attached to it. Air enters at the bottom and the fumes from the arc pass upward and into the cooling chambers, where the solid products are deposited. The air on returning to the bottom is thus relieved of these solids and the inner glass enclosure remains fairly clean. The lower carbon is impregnated with salts for producing the luminous flame and the upper carbon is cored. The life of the electrodes is about seventy-five hours.
The next step was the introduction of the so-called "luminous-arc" which is a "flame-arc" with entirely different electrodes. The lower (negative) electrode consists of an iron tube packed chiefly with magnetite (an iron oxide) and titanium oxide in the approximate proportions of three to one respectively. The magnetite is a conductor of electricity which is easily vaporized. The arc-flame is large and the titanium gives it a high brilliancy. The positive electrode, usually the upper one, is a short, thick, solid cylinder of copper, which is consumed very slowly. This lamp, known as the magnetite-arc, has a luminous efficiency of about 20 lumens per watt with a clear glass globe.
The mechanisms which strike the arc and feed the carbons are ingenious devices of many designs depending upon the kind of arc and upon the character of the electric circuit to which it is connected. Late developments in electric incandescent filament lamps have usurped some of the fields in which the arc-lamp reigned supreme for years and its future does not appear as bright now as it did ten years ago. High-intensity arcs have been devised with small carbons for special purposes and considered as a whole a great amount of ingenuity has been expended in the development of arc-lamps. There will be a continued demand for arc-lamps, for scientific developments are opening new fields for them. Their value in photo-engraving, in the moving-picture production studios, in moving-picture projection, and in certain aspects of stage-lighting is firmly established, and it appears that they will find application in certain chemical industries because the arc is a powerful source of radiant energy which is very active in its effects upon chemical reactions.
The luminous efficiencies of arc-lamps depend upon so many conditions that it is difficult to present a concise comparison; however, the following may suffice to show the ranges of luminous output per watt under actual conditions of usage. These efficiencies, of course, are less than the efficiencies of the arc alone, because the losses in the mechanism, globes, etc., are included.
| Lumens per watt | |
|---|---|
| Open carbon arc | 4 to 8 |
| Enclosed carbon arc | 7 |
| Enclosed flame-arc (yellow or white) | 15 to 25 |
| Luminous arc | 10 to 25 |
Another lamp differing widely in appearance from the preceding arcs may be described here because it is known as the mercury-arc. In this lamp mercury is confined in a transparent tube and an arc is started by making and breaking a mercury connection between the two electrodes. The arc may be maintained of a length of several feet. Perhaps the first mercury-arc was produced in 1860 by Way, who permitted a fine jet of mercury to fall from a reservoir into a vessel, the reservoir and receiver being connected to the poles of a battery. The electric current scattered the jet and between the drops arcs were formed. He exhibited this novel light-source on the mast of a yacht and it received great attention. Later, various investigators experimented on the production of a mercury-arc and the first successful ones were made in the form of an inverted U-tube with the ends filled with mercury and the remainder of the tube exhausted.
Cooper Hewitt was a successful pioneer in the production of practicable mercury-arcs. He made them chiefly in the form of straight tubes of glass up to several feet in length, with enlarged ends to facilitate cooling. The tubes are inclined so that the mercury vapor which condenses will run back into the enlarged end, where a pool of mercury forms the negative electrode. The arc may be started by tilting the tube so that a mercury thread runs down the side and connects with the positive electrode of iron. The heat of the arc volatilizes the mercury so that an arc of considerable length is maintained. The tilting is done by electromagnets. Starting has also been accomplished by means of a heating coil and also by an electric spark. The lamps are stabilized by resistance and inductance coils.
One of the defects of the light emitted by the incandescent vapor of mercury is its paucity of spectral colors. Its visible spectrum consists chiefly of violet, blue, green, and yellow rays. It emits virtually no red rays, and, therefore, red objects appear devoid of red. The human face appears ghastly under this light and it distorts colors in general. However, it possesses the advantages of high efficiency, of reasonably low brightness, of high actinic value, and of revealing detail clearly. Various attempts have been made to improve the color of the light by adding red rays. Reflectors of a fluorescent red dye have been used with some success, but such a method reduces the luminous efficiency of the lamp considerably. The dye fluoresces red under the illumination of ultra-violet, violet, and blue rays; that is, it has the property of converting radiation of these wave-lengths into radiant energy of longer wave-lengths. By the use of electric incandescent filament lamps in conjunction with mercury-arcs, a fairly satisfactory light is obtained. Many experiments have been made by adding other substances to the mercury, such as zinc, with the hope that the spectrum of the other substance would compensate the defects in the mercury spectrum. However no success has been reached in this direction.