Removing the work
The full size of the loom is 10 × 13 inches, upon which a rug 9 × 12 inches can be woven. It is made adjustable to innumerable smaller square and oblong sizes, by two devices. To regulate the length, the head piece, which is movable, can be let down on brass buttons, which are disposed along the sides at intervals of an inch. Perforations are placed half an inch apart in the head and foot pieces so that the side rods can be moved inward to regulate the width. They also insure straight edges, since the woof threads are passed around them as the work progresses. The rods also serve another important function as fulcrums upon which the needle may be pressed up and down, so that it passes more easily over and under the successive warp strings. The notches are one-sixteenth inch and the teeth one-eighth inch apart, giving opportunity for warp one-half, three-eighths, and three-sixteenths inches wide. The loom has an easel support, so that the pupil need not bend over it—an important consideration in school classes, and in home work as well. This support makes it possible to use the loom for an easel in the painting lessons, by resting a piece of pasteboard against it. The needle, which is longer than the warp is wide, serves also as a heddle in pressing the woof threads together evenly. It is furnished with an eye for worsted, chenille, carpet ravelings, or rope silk, and three slits for rags. To thread the needle with rags, pass the strip up and down through the slits and back again under the strip through the first slit. This binds the strip securely. In finishing the work weave the last few woof threads with a large tape needle, putting it up and down, over one thread at a time, as you would sew on canvas. It has been found desirable with children to push about an inch of woof threads close to the head piece and then fill in the space. Care should be taken not to pull the woof too tight. If these directions are followed and the warp is strung correctly the strings will not slip out of the notches. In adjusting the loom it will be found that the width from rod to rod is a little more than is required. For instance, for a rug nine inches wide, the width from rod to rod will be about nine and one-half inches. This is to allow for the springing together when the work is finished. To remove it from the loom, pull the rods gently upward and out. Then lift the warp strings out of the notches.
The Todd adjustable hand loom, Style a
Use of the primitive loom
The primitive loom can be used by following these same directions, but the work will, of course, be limited.
For school and home work
While a great deal of the work is intended for the schoolroom, many suggestions are given for home weaving, in making various articles for birthday and holiday gifts.