Practical taxidermy

by Montagu Browne

Yet another modification of the same springe. The wand or spring-stick, crosspiece, and nooses as before, but instead of the simple catch, use a complete bow, with both ends stuck in the ground. At some little distance from this drive in a straight piece of stick; next procure a piece of stick with a complete fork or crutch at one end. To set it, draw down the spring-stick and pull the crosspiece under the bow by the top side farthest from the spring-stick. Now hold it firmly with one hand while you place the forked stick with its crutch pressing against the opposite upright stick, and bring its free end against the lower end of the crosspiece, and adjust both as finely as you can. Finally, arrange the nooses in such a manner that if either of them or the crutched stick is touched the latter falls, and releasing the crosspiece, the spring-stick flies up, and the bird with it.

To see the setting of this at a glance, vide Fig. 3 (showing only one noose, however), which I have "cribbed" from a tail piece of Bewick's, putting it a little out of drawing to show it up.

Fig. 3 — "Springe" for Snipe.

The next simple trap to be considered is evidently the pit-fall, used only, however, for large and fierce animals, and varying in construction in different countries. For descriptions of methods of baiting for and catching such animals as lions, leopards, tigers, elephants, etc.., consult almost any book on African or Indian field sports.

Of poisons or intoxicants for capturing birds or animals, I do not intend to treat, as they are better left to gamekeepers and poachers.

Dead-falls, such as the "Figure of 4 trap," are easy to make, and useful for killing small animals. The materials required are simply three ordinary pieces of wood, a small piece of string, or, better still, wire, and a large, heavy, flat paving stone, or slate. Having procured three pieces of wood of half an inch square by one foot long, we call one the "upright," which is simply brought to a point at one end, somewhat like a chisel. The second is the "slanting stick," which should be cut to about 8 in. long, having a nick in it about half an inch from one end, about half way through its depth; the other end is brought to a chisel point on its upper surface; the third, which is the "foot" or "bait stick," has a square notch, the thickness of the upright, cut in it, about three inches from one end; the inner end of this notch is relieved a little, so as not to bind on the upright too much. Within half an inch of the other end another notch is cut, but at right angles to the last, that is to say, this last notch is cut on the top, while the other is cut at the side; the outer or top notch also slopes inward. At the inner or side notch end drill a little hole, through which place a piece of pointed wire to receive the bait.

The appearance of the three sticks when set is best explained by Fig 4; A. is the upright, B the slanting stick, and C bait or bottom stick. To set it, take the upright in the left hand, chisel point up, pick up B with the right hand, place it with its notch fitting on the top of A, and keeping the slanting stick pressed down firmly, you hold the two in proper position. This has relieved the left hand entirely, which now is used to pick up c; place the side notch of this on the upright A, slide it up until its end nick is caught by the point of B; a sufficient leverage, as it were, being attained on this, we can hold the whole of the trap now with the right hand. By grasping B with the fingers of the hand in opposition to the palm, while the thumb presses it down on the top, the left hand, being at liberty, is used to drag the stone and to raise one end to fall on the top of B; the weight of the stone now sets the three parts in opposition to each other. An animal touching the bait in the slightest manner is sufficient to destroy the nice balance of the whole affair, and down it comes with a run. The sizes given — from a trap I have just set — are, of course, for small animals only, but it may be enlarged or decreased to any extent, at the pleasure of the operator.

Fig. 4 — "FIGURE of 4" TRAP.