ATDT37031378
The modem will try to call 37031378, the number to my BBS. (You may have to prefix the number with an international code, and the country code for Norway. If international calls require the prefix 009, enter ATDT009-47-37031378). Your modem will wait for CONNECT a preset number of seconds (rarely longer than 60 seconds). If your modem does not detect the dial tone (within the preset waiting time), it will give you the following error message
NO DIALTONE
All other messages (except ERROR) declare that the modem did detect the dial tone. If it did, continue reading from "Configuring your program."
NO DIALTONE —————- The most probable causes of NO DIALTONE are that your phone cable is not connected, that it has been damaged, or that it is the wrong cable for the job. The latter cause is common in many countries. For example, a cable made for a telephone network in the United States, may not work in Norway. A cable made for connection to a switchboard, may not work when connected to a domestic phone line. A standard, domestic American phone cable contains four lines. Two of these (line number 1 and 4) carry sounds. The others are not being used. A standard Norwegian domestic cable is set up in the same way, but here line number 1 and 3 carry sound. Changing the configuration of such cables is often simple. Just cut the cable in two, and put the lines together correctly. This is typically required when your modem assumes that you use it in North America, while you are in a country with different cabling.
Configuring your program ———————————— The modem answers. The dial tone is being detected. Procomm is installed on your hard disk. Now, check if the program has been correctly configured. Press ALT-S to get the Setup Menu. Select 1, Modem setup, from this menu. Choice 1, Modem init string, is a general setup command. This command will be sent to the modem each time you start Procomm. You are free to make is as long and powerful as you want. Our purpose now, however, is to check if it works.
Most modems do not react if one element in your setup command is wrong. They respond with ERROR (or the numeric code), and disregard the rest.
Procomm's standard Modem init string has the following commands:
ATE0 S7=60 S11=55 V1 X1 S0=0!
These work well with most modems, provided the speed is legal. Go back to the blank screen (using ESC). Test the init command by entering it manually. (Do not enter the "!" character. This is Procomm's code for ENTER.) If the modem reacts with ERROR, check with the modem manual to find out what is wrong. (Check if the values S7=60 and S11=55 are not too high.) If you have to change the init command, go back to the Modem init string menu choice. Enter the correct commands. Remember to add the "!" at the end. Press ESC to get to the main configuration menu and select 2, TERMINAL SETUP. Check if Terminal emulation is ANSI-BBS. Change choice 2, Duplex, to FULL. The other factory settings are NONE, CR, CR, DEST, BS, OFF, ON, 350, OFF. Return to the SETUP MENU (press ESC). Press "s" to save the setup to disk. Your setting has now been stored, and Procomm is ready to be used.