Putting Cells In Case
When the covers have all been sealed, put the cells in the case, taking care to put the negative and positive posts in their proper positions, so that each cell connector will connect a positive to a negative post.
In Types MHA, KXD, LXRE, and XE, which have wooden spacers between the cells, take care that the spacers are in position and then, after cells are in place, tighten the tie bolts with a screw driver to clamp the jars.
In Types DX, LX, LXR, LXRV, SX, XC, XX, and XXV the cells should fit tight in the case; pack them in with thin boards if necessary.
Burning on the Cell Connectors
See instructions on pages [213] to 216.
See also instructions on page [373].
Not sooner than ten to fifteen hours after filling battery with electrolyte, add electrolyte to restore level if it has fallen.