Material Required for Making a Boxville Church: one shoe-box with its cover, one narrow box about six or seven inches long, one oblong box cover three or four inches long, three small box covers of about the same size (three inches), a twelve-inch square of cardboard, and some colored tissue-paper, with a spool.
Ding! Ding! Can you hear the bell in the steeple of the Boxville Church ringing? It does not ring very loud, because it is such a small bell, but it does ring beautifully! You can try it yourself. Suppose that you make a little church like this for your village!
Take a shoe-box. Remove its cover. Lay the shoe-box upon one long side rim. The bottom of the box will become the side of the church. It will need to have three long windows cut in it.
Draw these window spaces long and narrow, about one inch wide and three inches high. Cut the two end windows equally distant from the ends of the box, and draw the outline of the center window mid-way between these two. Cut the cardboard at the top of the window spaces to a point. (For cutting windows, see [Diagram One, A], page 166.)
If you have some colored tissue-paper, you may cut three pieces the same shape as the window spaces you have cut out. Let them be a little wider and longer, however. Paste each inside the box right over the open window spaces. This will make stained-glass windows. You can paint the window-casings with black ink, or paint on the outside of the box around the windows.
If you prefer, you can make the window-casings by pasting narrow strips of pinwheel paper around the windows, instead of using the paint.
The Boxville Church, as you can see, has a sloping roof. This roof is the cover of the shoe-box supported on two side walls, which are made of cardboard and glued to each end of the box. You will need to cut these side walls. (See [Diagram Three, A], page 168.)
Measure the exact width and height of your box on the twelve-inch square of cardboard. Measure one end only, and place the end of the box so that it comes at the edge of your cardboard. At the top, add four inches to the height, and cut out this oblong piece you have drawn. Make another like it. Next, cut off the two front upper corners diagonally down to the mark you first made, showing the height of your box building at the front of your box.
Cut a church door in one of these sides. Make it rather high—about the height of the church windows. Let the base of the door come at the lower edge of the side wall. Cut up through the cardboard vertically for about three inches. Then cut the arch of the door and bend as if it were on a hinge. (See [Diagram Two, A], page 167, for cutting door.)
Paste each side wall in place on the box building so that the points of each come at the rear of the box. When the side walls are firmly dry, cut out the cardboard that is under the door space of the side wall. The roof is not quite ready to go on yet, however. You will first need to arrange for the steeple or bell-tower.