A Lamp-furnace is exceeding useful for all operations that require only a moderate, but long-continued, degree of heat. The furnace for working with a lamp-heat is very simple: it consists only of a hollow cylinder, from fifteen to eighteen inches high, and five or six in diameter, having at its bottom an aperture large enough for a lamp to be introduced and withdrawn with ease. The lamp must have three or four wicks, to the end that by lighting more or fewer of them a greater or less degree of heat may be produced. The body of the furnace must moreover have several small holes in it, in order to supply the flame of the lamp with air enough to keep it alive.
On the top of this furnace stands a bason five or six inches deep, which ought to fill the cavity of the cylinder exactly, and to be supported at its circumference by a rim which may entirely cover and close the furnace: the use of this bason is to contain the sand through which the lamp-heat is usually conveyed.
Besides this, there must be a kind of cover or dome made of the same material with the furnace, and of the same diameter with the sand-bath, without any other opening than a hole, nearly circular, cut in its lower extremity. This dome is a sort of reverberatory, which serves to confine the heat and direct it towards the body of the retort; for it is used only when something is to be distilled in a vessel of this fashion; and then the hole at its bottom serves for a passage to the neck of the retort. This dome should have an ear or handle, for the conveniency of putting it on and taking it off with ease.
Chymical vessels, especially such as are made of glass, and the earthen vessels commonly called stone-ware, are very subject to break when exposed to sudden heat or cold: whence it comes, that they often crack when they begin to heat, and also when being very hot they happen to be cooled, either by fresh coals thrown into the furnace, or by the access of cold air. There is no way to prevent the former of these accidents, but by taking the pains to warm your vessel very slowly, and by almost insensible degrees. The second may be avoided by coating the body of the vessel with a paste or lute, which being dried will defend it against the attacks of cold.
The fittest stuff for coating vessels is a composition of fat earth, Windsor-loam, fine sand, filings of iron, or powdered glass, and chopped cow's hair, mixed and made into a paste with water. This lute serves also to defend glass vessels against the violence of the fire, and to prevent their melting easily.
In almost all distillations it is of great consequence, as hath been said, that the neck of the distilling vessel be exactly joined with that of the receiver into which it is introduced, in order to prevent the vapours from escaping into the air and so being lost: and this junction is effected by means of a lute.
A few slips of paper applied round the neck of the vessels with common size will be sufficient to keep in such vapours as are aqueous or not very spirituous.
If the vapours are more acrid, or more spirituous, recourse may be had to slips of bladder long steeped in water, which containing a sort of natural glue, close the junctures of the vessels very well.