Fig. 250
Two cardboard seats, cut as in Fig. 251, should next be fastened by paper hinges to the inside of G.
To make the top of the cab cut a piece of cardboard, 4½ inches by 3 inches (Fig. 252). Make a half cut along A B and bend. Glue portion K to the back of the car A B, and L to the tops of the posts E D and to the sides F. If necessary a paper hinge can be used to fasten the top L to the front G.
A cardboard seat about 1 inch wide is glued to the block H for the driver. The sides of this seat (M in Fig. 248) are made of pieces of wood, 1½" × 1" × 1/8", one corner being rounded as in the figure, and they are glued to each side of the block H. Two pieces of cane should be glued on each side and to the roof.
Fig. 251
Fig. 252
