The Seaman's Friend / Containing a treatise on practical seamanship, with plates, a dictionary of sea terms, customs and usages of the merchant service

by Richard Henry Dana

Service is the laying on of spunyarn, or other small stuff, in turns round the rope, close together, and hove taut by the use of a serving-board for small rope, and serving-mallet for large rope. Small ropes are sometimes served without being wormed, as the crevices between the strands are not large enough to make the surface very uneven; but a large rope is always wormed and parcelled before being served. The service is put on against the lay of the rope.

Splicing, is putting the ends of ropes together by opening the strands and placing them into one another, or by putting the strands of the ends of a rope between those of the bight.

A Short Splice. (3.) Unlay the strands for a convenient length; then take an end in each hand, place them one within the other, and draw them close. Hold the end of one rope and the three strands which come from the opposite rope fast in the left hand, or, if the rope be large, stop them down to it with a rope-yarn. Take the middle strand, which is free, pass it over the strand which is first next to it, and through under the second, and out between the second and third from it, and haul it taut. Pass each of the six strands in the same manner; first those on one side, and then those on the other. The same operation may be repeated with each strand, passing each over the third from it, and under the fourth, and through; or, as is more usual, after the ends have been stuck once, untwist each strand, divide the yarns, pass one half as above described, and cut off the other half. This tapers the splice.

A Long Splice. (4.) Unlay the ends of two ropes to a distance three or four times greater than for a short splice, and place them within one another as for a short splice. Unlay one strand for a considerable distance, and fill up the interval which it leaves with the opposite strand from the other rope, and twist the ends of these two together. Then do the same with two more strands. The two remaining strands are twisted together in the place where they were first crossed. Open the two last named strands, divide in two, take an overhand knot with the opposite halves, and lead the ends over the next strand and through the second, as the whole strands were passed for the short splice. Cut off the other two halves. Do the same with the others that are placed together, dividing, knotting, and passing them in the same manner. Before cutting off any of the half strands, the rope should be got well upon a stretch. Sometimes the whole strands are knotted then divided, and the half strands passed as above described.

An Eye Splice. (5.) Unlay the end of a rope for a short distance, and lay the three strands upon the standing part, so as to form an eye. Put one end through the strand next to it. Put the next end over that strand and through the second; and put the remaining end through the third strand, on the other side of the rope. Taper them, as in the short splice, by dividing the strands and sticking them again.

A Flemish Eye. (6.) Take the end of a rope and unlay one strand. Form an eye by placing the two remaining ends against the standing part. Pass the strand which has been unlaid over the end and in the intervals round the eye, until it returns down the standing part, and lies under the eye with the strands. The ends are then scraped down, tapered, marled, and served over with spunyarn.

An artificial or Spindle Eye.—Unlay the end of a rope and open the strands, separating each rope yarn. Take a piece of wood, the size of the intended eye, and hitch the yarns round it. Scrape them down, marl, parcel, and serve them. This is now usually called a Flemish Eye.

A Cut Splice. (7.) Cut a rope in two, unlay each end as for a short splice, and place the ends of each rope against the standing part of the other, forming an oblong eye, of the size you wish. Then pass the ends through the strands of the standing parts, as for a short splice.

A Grommet. (8.) Take a strand just unlaid from a rope, with all its turns in it, and form a ring of the size you wish, by putting the end over the standing part. Then take the long end and carry it twice round the ring, in the crevices, following the lay, until the ring is complete. Then take an overhand knot with the two ends, divide the yarns, and stick them as in a long splice.

A single Wall Knot. (9.) Unlay the end of a rope. Form a bight with one strand, holding its end down to the standing part in your left hand. Pass the end of the next strand round this strand. Pass the remaining strand round the end of the second strand, and up through the bight which was made by the first strand. Haul the ends taut carefully, one by one.