The Seaman's Friend / Containing a treatise on practical seamanship, with plates, a dictionary of sea terms, customs and usages of the merchant service

by Richard Henry Dana

To furl a Jib.—Go out upon the weather side of the boom. See your gasket clear for passing. The handiest way usually is, to make it up on its end, take a hitch over the whole with the standing part, and let it hang. Haul the sail well upon the boom, getting the clew, and having the sheet pennant hauled amidships. Cast the hitch off the gasket, take it in your hand, and pass two or three turns, beginning at the head; haul them taut; and so on to the clew. Pass the turns over and to windward. This will help to bring the sail upon the boom and to windward. Make the end fast to the stay, to the withe, or to the boom inside the cap, in any way that shall keep it from slipping back, which it might do if made fast to its own part round the boom. If there is but one hand on the boom, the first turns may be hauled taut enough to keep the sail up for the time; then, after the gasket is fast, go out to the head, and haul each turn well taut, beating the sail down with the hand. Be careful to confine the clew well.

To stow a Jib in Cloth.—Haul the jib down snugly, and get it fairly up on the boom. Overhaul the after leech until you come to the first straight cloth. Gather this cloth over the rest of the sail on the boom, stopping the outer end of the cloth with a rope-yarn round the jib stay. If the jib halyards are double, stop the block inside the sail. Cover the sail well up with the cloth, stopping it at every two feet with rope-yarns round the sail and boom. If you are to lie in port for a long time, cast off the pennant, stow the clew on the boom, snugly under the cloth, which will be stopped as before with rope-yarns.

To reef a Topsail.—Round in on the weather brace, ease off the halyards, and clew the yard down by the clewlines and reef-tackles. Brace the yard in nearly to the wind, and haul taut both braces. Haul out the reef-tackles, make fast, and haul taut the buntlines. Before going upon the yard, see that it is well down by the lifts. Let the best men go to the yard-arms, and the light hands remain in the slings. Cast adrift the weather earing, pass it over the yard-arm outside the lift, down abaft and under the yard, and up through the reef-cringle. Haul well out, and take a round-turn with the earing round the cringle. Then pass several turns round the yard and through the cringle, hauling them well taut, passing the turns over the yard, down abaft and under, and up through the cringle.[ [3] Having expended nearly all the earing, hitch the remainder round the two first parts, that go outside the lift, jamming them together and passing several turns round them both to expend the rope. The bare end may be hitched to these two parts or to the lift. The men on the yard light the sail out to windward by the reef-points, to help the man at the weather yard-arm in hauling out his earing. As soon as the weather earing is hauled out and made secure by a turn or two, the word is passed—"Haul out to leeward," and the lee earing is hauled out till the band is taut along the yard, and made fast in the same manner. Then the men on the yard tie the reef-points with square knots, being careful to take the after points clear of the topgallant sheets.

In reefing, a good deal depends upon the way in which the yard is laid. If the yard is braced too much in, the sail catches flat aback and cannot be hauled out, besides the danger of knocking the men off the foot-ropes. The best way is to shiver the sail well till the yard is down, then brace it in with a slight full, make the braces fast, and luff up occasionally and shake the sail while the men are reefing. If you are going before the wind, you may, by putting your helm either way, and bringing the wind abeam, clew the yard down as the sail lifts, and keep her in this position, with the yard braced sharp up, until the sail is reefed; or, if you are not willing to keep off from your course, and the wind is very fresh, clew down and clew up, and reef as before directed.

All the reefs are taken in the same way except the close reef. In close reefing, pass your earing under the yard, up abaft and over, and down through the cringle. Pass all your turns in the same manner; and bring the reef-band well under the yard in knotting, so as to cover the other reefs.

As soon as the men are off the yard, let go the reef-tackles, clewlines, buntlines, and topgallant sheets; man the halyards, let go the lee brace, slack off the weather one, and hoist away. When well up, trim the yard by the braces, and haul out the bowlines. A reefed sail should never be braced quite sharp up, and if there is a heavy sea and the vessel pitches badly, ease the braces a little, that the yard may play freely, and do not haul the leech too taut.

To reef a Course.—As a course generally has no reef-tackle, you must clew it up as for furling, according to the directions before given, except that the clews are not hauled chock up. Lay out on the yard and haul out the earings, and knot the points as for the first reef of a topsail, seeing them clear of the topsail sheets. If a long course of bad weather is anticipated, as in doubling the southern capes, or crossing the Atlantic in winter, reef-tackles are rove for the courses.

If there are any studdingsail booms on the lower or topsail yards, they must be triced up before reefing.

To turn out Reefs.—For a topsail, haul taut the reef-tackles and buntlines, settle a little on the halyards, if necessary; lay aloft, and cast off all the reef-points, beginning at the bunt and laying out. Be careful to cast all off before slacking up the earing; for, when there is more than one reef, a point may be easily left, if care is not taken. Have one hand at each earing, cast off all the turns but enough to hold it, and when both earings are ready, ease off both together. Pass the end of the earing through the cringle next above its own, and make it fast slack to its own part by a bowline knot. Lay in off the yard, let go reef-tackles, clewlines, buntlines, and topgallant sheets; overhaul them in the top and hoist away, slacking the braces and trimming the yard. The reefs of a course are turned out a good deal in the same manner; slacking up the sheet and tack, if necessary, and, when the earings are cast off, let go clew-garnets, buntlines and leechlines, board the tack, and haul aft the sheet.

To set a Topgallant Studdingsail.—This sail is always set from the top; the sail, together with the tack and halyards in two coils, being kept in the top. If there is but one hand aloft, take the end of the halyards aloft, abaft everything, and reeve it up through the block at the topgallant mast-head, and down through the sheave-hole or block at the topgallant yard-arm, abaft the sheet, and bring it into the top, forward of the rigging, and make it fast to the forward shroud. Take the end of your tack out on the topsail yard, under the brace, reeve it up through the block at the end of the topgallant studdingsail boom, bring it in over the brace, overhauling a plenty of it so as to let the boom go out, and hitch it to the topmast rigging while you rig your boom out. Cast off the heel-lashing and rig your boom out to the mark, slue the boom with the block up and make fast round the yard. (The easiest way of passing the boom-lashing is to take it over the yard and put a bight up between the head-rope and yard; then take the end back over the yard and boom and through the bight, and haul taut. This may be done twice, if necessary, and then hitch it round all parts, between the boom and the yard.) The boom being rigged out and fast, take the end of your tack down into the top and hitch it to the forward shroud. Then take the coil of the tack and throw the other end down on deck, outside of the rigging and backstays. (It is well, in throwing the coil down, to keep hold of the bight with one hand, for otherwise, if they should miss it on deck, you will have to rig in your boom.) Throw down the hauling end of your halyards abaft and inside everything. Now get your sail clear for sending out. Lay the yard across the top, forward of the rigging, with the outer end out. Bend your halyards to the yard by a fisherman's bend, about one third of the way out. Take your tack under the yard and bend it by a sheet-bend to the outer clew, and pay down the sheet and downhaul through the lubber-hole. All being clear for hoisting, sway away on the halyards on deck, the men in the top guying the sail by the sheet and downhaul, the latter being hauled taut enough to keep the outer clew up to the inner yard-arm. (Sometimes it is well to make up the downhaul as is done with the downhaul of the topmast studdingsail.) When the sail is above the brace, haul out on the tack, sway the yard chock up by the halyards, and trim the sheet down. Make the end of the downhaul fast slack.