Up to now, the only things we could have called “industries” were the worked stone industry and perhaps the worked (?) bone industry of the Peking cave. We could add some of the very clear cases of open air sites, like Olorgesailie. We couldn’t use the term for the stone tools from the glacial gravels, because we do not know which tools belonged together. But when the cave materials begin to appear in Europe, we can begin to speak of industries. Most of the European caves of this time contain industries of flint tools alone.
THE EARLIEST EUROPEAN CAVE LAYERS
We’ve just mentioned the industry from what is said to be the oldest inhabited cave in Europe; that is, the industry from the deepest layer of the site at Fontéchevade. Apparently it doesn’t amount to much. The tools are made of stone, in the flake tradition, and are very poorly worked. This industry is called Tayacian. Its type tool seems to be a smallish flake tool, but there are also larger flakes which seem to have been fashioned for hacking. In fact, the type tool seems to be simply a smaller edition of the Clactonian tool (pictured on [p. 45]).
None of the Fontéchevade tools are really good. There are scrapers, and more or less pointed tools, and tools that may have been used for hacking and chopping. Many of the tools from the earlier glacial gravels are better made than those of this first industry we see in a European cave. There is so little of this material available that we do not know which is really typical and which is not. You would probably find it hard to see much difference between this industry and a collection of tools of the type called Clactonian, taken from the glacial gravels, especially if the Clactonian tools were small-sized.
The stone industry of the bottommost layer of the Mount Carmel cave, in Palestine, where somewhat similar tools were found, has also been called Tayacian.
I shall have to bring in many unfamiliar words for the names of the industries. The industries are usually named after the places where they were first found, and since these were in most cases in France, most of the names which follow will be of French origin. However, the names have simply become handles and are in use far beyond the boundaries of France. It would be better if we had a non-place-name terminology, but archeologists have not yet been able to agree on such a terminology.
THE ACHEULEAN INDUSTRY
Both in France and in Palestine, as well as in some African cave sites, the next layers in the deep caves have an industry in both the core-biface and the flake traditions. The core-biface tools usually make up less than half of all the tools in the industry. However, the name of the biface type of tool is generally given to the whole industry. It is called the Acheulean, actually a late form of it, as “Acheulean” is also used for earlier core-biface tools taken from the glacial gravels. In western Europe, the name used is Upper Acheulean or Micoquian. The same terms have been borrowed to name layers E and F in the Tabun cave, on Mount Carmel in Palestine.
The Acheulean core-biface type of tool is worked on two faces so as to give a cutting edge all around. The outline of its front view may be oval, or egg-shaped, or a quite pointed pear shape. The large chip-scars of the Acheulean core-bifaces are shallow and flat. It is suspected that this resulted from the removal of the chips with a wooden club; the deep chip-scars of the earlier Abbevillian core-biface came from beating the tool against a stone anvil. These tools are really the best and also the final products of the core-biface tradition. We first noticed the tradition in the early glacial gravels ([p. 43]); now we see its end, but also its finest examples, in the deeper cave levels.
The flake tools, which really make up the greater bulk of this industry, are simple scrapers and chips with sharp cutting edges. The habits used to prepare them must have been pretty much the same as those used for at least one of the flake industries we shall mention presently.