SECTION IV.
ARTICLE I.
Observations on the quality of Rye for distilling.
The best rye for distilling is that which is thoroughly ripe, before it is cut, and kept dry till threshed; if it has grown on high or hilly ground, it is therefore to be preferred, being then sounder and the grain fuller, than that produced on low level land—but very often the distiller has no choice, but must take that which is most convenient;—great care however ought to be observed in selecting sound rye, that has been kept dry, is clean and free from cockle, and all kind of dirt, advantages will result from fanning it, or running it through a windmill before it is chopped.
ART. II.
Mode of chopping Rye and the proper size.
The mill stones ought to be burrs, and kept very sharp for chopping rye for distillation; and the miller ought to be careful not to draw more water on the wheel than just sufficient to do it well, and avoid feeding the stones plentifully; because in drawing a plentiful supply of water, the wheel will compel a too rapid movement of the stones, of course render it necessary they should be more abundantly fed, which causes part to be ground dead, or too fine, whilst part thereof will be too coarse, and not sufficiently broken, so that a difficulty arises in scalding—for in this state it will not scald equally, and of consequence, the fermentation cannot be so good or regular; and moreover as part of it will merely be flattened, a greater difficulty will arise in breaking the lumps, when you mash and stir your hogsheads. If burr stones are very sharp, I recommend the rye to be chopped very fine, but to guard against over-seeding, or pressing too much on them; but if the stones are not sharp, I would recommend the rye should be chopped about half fine. Distillers in general sustain a loss from having their rye chopped so coarse as I have observed it done in common.