51. Composition and Preparation of Asphalt Surface Mixture.—The surface-course shall be composed of the materials specified in Sections 43, 44, 45, 46, 47, 48, 49, and 50 mixed in such ratios by weight as the Engineer may direct or approve. A typical mixture will contain:
| Sand | 100.0 lbs. |
| Pulverized mineral matter passing No. 200 screen, including that found in the paving cement | 17.5 lbs. |
| Pure bitumen (in paving cement) | 13.5 lbs. |
But the quantities of pulverized stone and of asphaltic cement shall be varied as may be found necessary or desirable by the Engineer to suit the purity of the asphaltic cement, the character of the sand, the climatic conditions, and the varying quantity and character of travel on the street to be paved; and Portland cement may be substituted partly or wholly for the pulverized stone, when directed by the Engineer. The surface-course mixture shall be submitted to the Engineer and approved by him before any is laid upon the street.
The mixing shall be accomplished in a mechanical mixing apparatus capable of rapidly and effectually incorporating the materials together, and each batch must remain in the mixer a sufficient length of time to effect a perfect mixture. The sand shall be separately heated and shall reach the mixing apparatus at a temperature not above three hundred and fifty (350) degrees F., nor below three hundred and twenty (320) degrees F. The pulverized stone shall be at such a temperature that when mixed with the sand the temperature of the mixed mass shall not be above three hundred and fifty (350) degrees F., nor below three hundred and twenty (320) degrees F. The sand shall be first placed in the mixer, followed by the pulverized stone, and these two materials shall be thoroughly mixed together before the asphaltic cement is added. The asphaltic cement at a temperature not above three hundred and fifty (350) degrees, nor below three hundred (300) degrees F. shall then be added in such a way as to evenly distribute it over the sand and pulverized stone, and the mixing continued until the materials are thoroughly incorporated into a perfectly uniform and homogeneous mass, with the grains of sand completely covered with cement. Suitable thermometers shall be constantly used to determine the temperatures specified herein. Great care must be taken to accurately weigh and proportion the materials charged into the mixer.[[22]]
52. Stone for Base-course.—Stone screenings for base-course shall be of crushed, hard, durable stone. The portion used shall all be retained upon a No. 8 sieve, or screen, and shall all pass a screen having square meshes, the linear dimensions of the openings in which are one-half (½) inch less than the thickness of the base-course.
53. Composition of Base-course.—The base-course shall be composed of the crushed stone specified in Section 52, mixed with the asphaltic cement, sand and pulverized stone specified in Sections 50, 48 and 49, but the asphaltic cement shall be of such hardness as the engineer may direct.
A typical base-course mixture will be composed as follows:
| Crushed stone | 100 | lbs. |
| Sand | 42 | lbs. |
| Pure bitumen (in asphaltic cement) | 7 | lbs. |
| Pulverized stone | 7½ | lbs. |
But the mixture shall be such that when placed on the street and compressed by the roller the mass shall be dense and the voids in the stone completely filled; and to accomplish this the quantity of crushed stone used in the mixture may be increased or decreased, as the volume of its voids may require, in order that they may be completely filled.[[23]]
54. Mixing the Base-course.—The materials for the base-course shall be heated and mixed in the same general manner as prescribed for the surface-course (Sect. 51), the crushed stone being delivered first in the mixer. The temperature of the mixture as it comes from the mixer being not above three hundred and twenty-five (325) degrees F., nor below three hundred (300) degrees F.