Fig. 50. Darning lost in the ground.
Fine drawing (fig. [51]).—The art of making invisible darns in cloth, though such a useful one, is all but unknown. It is a tedious process and one which, though easy enough to understand, requires great care in the execution.
Use as fine a needle as possible and thread it with hair, instead of silk, or any other kind of fibre. Red and white hair is the strongest, and stronger than the ravellings of the stuff. Of course the hair has first to be carefully cleansed from grease. Pare the edges of the rent, on the right sides, quite clean and even, with a razor, so that both rent and stitches may be lost in the hairy surface of the cloth. Scissors do not cut so closely, and are liable moreover, to disturb the nap, and render the darn more visible. When this is done, fit the edges exactly together, and overcast them. Then thread a needle with a hair by the root, and slip it in, 2 or 3 m/m. from the one edge and back again pointed towards you, through the other, so that, neither needle nor hair, are visible on either side. The stitches should be set slightly slanting and must be quite lost in the thickness of the cloth. The needle must always be put in, exactly at the place where it came out, and the hair not be too tightly drawn.
When the darn is finished, lay the article on a bare table, or ironing-board, cover it with a damp cloth, and iron it. The sharpest eye will fail to detect a rent, when carefully darned in this manner.
Patching.—As we have already said, when the defective part is past darning, it must be cut out, and a new piece of stuff inserted in its place. If the garment be no longer new, it should be patched with a slighter material than that of which it was originally made. The patch should be of the same shape, and cut the same way of the stuff, as the piece it is to replace, it should also be, just so much larger, as to allow for the turnings in, and can either be top-sewn, or else, run and felled in.
Back-stitching and felling in a patch (fig. [52]).—Tack in the new piece, so that its edges overlap the edges of the hole. The back-stitching must be done on the article itself, as this renders it easier to do the corners neatly. The hem is turned down on to the patch. Make a little snip at the corners with your scissors to prevent puckering. The back-stitching should form a right angle at each corner.
