Second and third position of the hands (figs. [615] and [616]).—Carry the thread down behind the second, third, fourth and fifth fingers, and put the needle through the loop on the fingers and behind the mesh, through the foundation loop, thus forming a second loop, which you hold back with the little finger of the left hand. Then gradually drawing up the thread that runs from the mesh, let go the loop held down by the thumb; then by degrees let go also, the loop which lies over the second, third and fourth fingers, still holding the last loop fast with the little finger; finally you release this too and pull up the knot thus formed close to the mesh with the right hand. This completes the stitch. The next stitches are made in the same way; whether they are to serve for casting on or for a netted foundation. The mesh is drawn out at the end of each row, the work turned and the mesh held beneath the last row, in readiness for the next, in making which you pass your needle through each loop. These diamond-shaped loops form a diagonal net.
Fig. 616. Third position of the hands.
2º Double loop.—To make a double loop put the thread two or three times round the mesh.
3º Oblong loop.—For oblong loops, the knots must be made a little distance from the mesh.
4º Honeycomb loop.—Make an oblong loop, pass the thread round the fingers, but not over the mesh as in plain netting, put the needle, not into the loop of the previous row, but between the loop, just made. The knot which is made in the same way as in plain netting, must be drawn close up to the mesh; the two threads of the loop should lie side by side on the mesh. The loops in honeycomb netting are six-sided.
5º Twisted loops.—Pass the thread, as in plain netting, over the mesh and fingers, but before letting the thread which is under the thumb go, pass the needle from right to left under the loop you are making and the thread, and only then draw up the knot.
Although in netting the loops cannot be formed in as many different ways as in knitting or crochet, they admit of a certain variety, as the following explanations will show.
Patterns produced in netting by using meshes of different widths.—Plain netting can be varied by making one row of loops over a large mesh and one over a small one, or several rows over the large and several over the small, alternately, changing the meshes at regular intervals.
Patterns produced in netting by increasing and decreasing (fig. [617]).—Patterns of this kind are made by netting the meshes together in regular sequence and taking up as many meshes as you have netted together, or vice versa. You may increase and decrease in the same rows, or at an interval of so many rows.