Stripe in flat and raised satin stitch, and madeira embroidery.
White Embroidery.
We have retained the familiar term, white embroidery, for this kind of needlework, for convenience sake, in spite of its inaccuracy, now that coloured materials are quite as much used for it as white.
It is executed, either on a backing of oil-cloth, or in an embroidery frame, called «tambour-frame». Only skilful workers can dispense with these, for an untrained hand can hardly avoid puckering. If you work without a foundation, the material must be held, quite smoothly over the forefinger, so that the threads lie perfectly straight, otherwise, the pattern is very apt to get pulled out of shape in the working. With your three other fingers you hold the material fast, the thumb resting on the work itself, beyond the outline of the pattern, which must be turned towards the worker. It is always the outside line of a pattern that is drawn in double lines, that should be turned towards the palm of the hand.
Tracing patterns.—Patterns are generally to be had ready traced, but as it is often necessary to repeat, enlarge, or reduce them, descriptions of several modes of doing so, will be found at the end of the concluding chapter.
Materials.—A loose, soft make of cotton, the looser the better, and very little twisted, is the best material for embroidery. We recommend for white embroidery in general, Coton à broder D.M.C Nos. 16 to 150; for monograms on cambric, Coton à broder surfin D.M.C Nos. 100, 120, 150;[A] and for English or Madeira embroidery, Coton Madeira D.M.C Nos. 40, 50, 60;[A] for padding, or raising the embroidery, all the different kinds of Coton à repriser D.M.C[A] can be used.
Outlining and padding.—The outlining of a pattern is a very important preliminary. A want of precision in the ultimate effect is often due, merely to careless outlining. This part of the work should be done with rather a coarser cotton than the embroidery itself. Fasten in the thread by a few running stitches, never with a knot, a rule to be observed also in embroidering, except in very rare cases. Finish off your thread by drawing it through the tracing stitches, or through some part of the pattern that is already finished. Fill in the spaces between the lines with a padding of run threads, run loosely, and so that they lie thickly and solidly in the centre, and shade off on both sides. The fullness, and roundness of embroidery, depends on the firmness of this sub-stratum of threads. The outlining and the padding of the different rounded and pointed scallops, as well as of other figures that occur in white embroidery, are illustrated in figs. [181], [182], [183], [184], [185], [187], [189], [190] and [191].
Blanket, or button-hole stitch (fig. [171]).—Work from left to right; run in a foundation line, hold down the working thread below the run line with the right thumb; insert the needle above and bring it out below the run line but above the working thread; tighten the loop thus formed, without drawing up the stuff, and continue in this manner, setting your stitches closely and regularly, side by side.