Water gets beneath the surface by processes which are readily seen. Wherever the soil is porous some of the rain which falls upon it is absorbed. Sinking through the soil to the solid rock it finds cracks and pores through which it descends to great depths. Nowhere are the rocks beneath the mantle rock so compact and so free from cracks, when any considerable area is considered, as to prevent the percolation of water through them.
Conditions influencing descent of rain-water.—There are several conditions which influence not only the amount of water which sinks beneath the surface in a given area, but the proportion of the precipitation which follows this course. These are as follows: (1) Amount of precipitation.—In a general way it is true that the greater the amount of precipitation the greater the amount of water which will sink beneath the surface. Other things being equal, a region of heavy precipitation is a region where wells are easily obtained and springs common. (2) Rate of precipitation.—A given amount of precipitation may be concentrated in a short interval, or distributed through a considerable period of time. In the latter case more of the water sinks beneath the surface; in the former, a larger proportion runs off over the surface. The reason is readily seen. Water passes through small spaces, such as those of soil, slowly, and its rate of passage decreases rapidly with decreasing size of the passageways. When rain falls rapidly on a surface of even moderately close texture, the uppermost layer of soil is promptly filled with water, and since the water passes downward slowly, the uppermost saturated part of the soil becomes virtually impervious. While in this condition, the water which falls on it will run off if there be slope, and stand if there be none. In the latter case it will sink slowly as the water in the soil passes down to lower levels. If precipitation takes place no faster than the water can sink through the soil, all the water may become ground-water. (3) The topography of the surface has much to do with determining the proportion of rainfall which becomes ground-water. If the surface be flat, more will sink in; if it be sloping, more of it will run off before it has time to sink. Other things being equal, the steeper the slope the larger the proportion of the rainfall which will run off over it. (4) The texture of the soil, or other material on which the rain falls, helps to determine what proportion of it sinks beneath the surface. If the surface materials be porous, the water sinks readily; if of close texture, it finds less ready ingress. Other things being equal, the closer the texture of the soil the less the proportion of the rainfall which will enter it. (5) The texture and structure of the rock beneath the surface have some influence on the amount of ground-water. The rock may be stratified or massive; it may be abundantly or sparsely jointed; it may be porous or compact. On the whole, stratified rock is more favorable for the entrance of water than unstratified, partly because of its greater average porosity, and partly because the planes of division between beds often allow the passage of water. If the beds of stratified rock are vertical or inclined, water finds its way into them more readily than if they are horizontal, in so far as it descends along stratification planes. Horizontally bedded rock, or rock which is not bedded at all, may be so much jointed, and the joints so open, as to allow the water to enter readily.
The conditions favorable to the sinking of abundant water below the surface are therefore heavy precipitation, falling slowly on a surface with little relief, a soil of open texture underlain by rock which is porous, or affected by vertical or highly inclined planes of cleavage. The annual discharge of water by rivers is estimated to be about 22 percent. of the rainfall on the land.[93]
Supply of ground-water not altogether dependent on local rainfall.—The amount of ground-water in a given region is not always entirely dependent on the local rainfall. Ground-water is in constant movement, and entering the soil or rock at one point it may, after a long subterranean journey, reach a point far from that at which it entered. Thus beneath the Great Plains of the West there is much subterranean water which fell on the eastern slopes of the mountains to the west. It has flowed beneath the surface to the Plains, where some of it is now withdrawn for the purposes of irrigation in regions where rainfall is deficient. The accompanying diagram ([Fig. 199]) illustrates the flow here described.
Fig. 199.—Diagram illustrating the general point that ground-water is not dependent entirely upon local supply.
Fig. 200.—Diagram illustrating the position of the ground-water surface (the dotted line) in a region of undulatory topography.
The ground-water surface. Water table.—The water table has already been defined ([p. 71]) as the upper surface of the ground-water. In a flat region of uniform structure the ground-water surface is essentially level, but rises and falls with the rainfall. Where the topography of a region is not flat, the ground-water surface is not level. As a rule it is higher, though farther below the surface, under an elevation than under surrounding lowlands, as illustrated by [Fig. 200]. The explanation is not far to seek. If a hill of sand be exposed to rainfall, most of the water falling on its porous surface will sink into it. If the precipitation continues long enough, as in a protracted rain, the hill of sand will be filled with water, the water occupying the interstices between the grains. If the sand of the hill could be removed, leaving the water which it contains on the same area, it would constitute a mound perhaps a third or a fourth as high as the hill itself. If unsupported, this mound of water would spread promptly in all directions until its surface was level. While the sand remains, the water in it constitutes a mound, and has a tendency to spread. It does in fact spread, but since the process involves great friction the spreading is slow. With the spreading the surface of the water in the sand sinks, and sinks fastest at the center where it is highest (b, [Fig. 201]). If the process were not interrupted the surface of the water in the hill would, in time, sink approximately to the level of the water in the surrounding land (d, [Fig. 201]); but at every stage preceding the last, the surface of the water would be higher beneath the summit of the hill than elsewhere, though farther from the surface. In regions of even moderate precipitation the water surface beneath the hills rarely sinks to the level of that in the lowlands adjacent, before being raised by further rains.
