Geology, Vol. 1 [of 3]

by Thomas C. Chamberlin; Rollin D. Salisbury

By far the larger part of the sediment acquired by a normal stream is made up of material loosened in advance by the processes of weathering. The stream, or the waters which get together to make the stream, find them ready-made; but rivers frequently wear rock which is not weathered, for the principal valleys of the earth’s surface are cut in solid rock, and many of them in rock of exceeding hardness. How does the stream wear the solid rock?

When a stream flows over a rock bed, the wear which it accomplishes depends chiefly on the character of the rock, the velocity of the stream, and the load it carries. If the rock be stratified and in thin layers, and if these thin layers be broken by numerous joints at high angles to the stratification planes, the impact of the water of a clear stream of even moderate strength may be effective in dislodging bits of the rock. This condition of things is often seen where streams run on beds of shale or slate. If the rock be hard and without bedding-planes and joints, or if its layers be thick and its joints few, clear water will be much less effective. If the surface of the rock be rough, the mechanical action of a swift stream of clear water might still produce some effect on it; but if massive hard rock presents a smooth surface to a clear stream, the mechanical effect of even a swift current is slight.

This general principle is illustrated by the Niagara River. Just above the falls the current is swift. When the river is essentially free from sediment, the surface of the limestone near the bank beneath it is sometimes distinctly green from the presence of the one-celled plants (fresh-water algæ) which grow upon it. The whole force of the mighty torrent is not able to sweep them from their moorings. Were the stream supplied with a tithe of the sand which it is capable of carrying, it would not take many hours, and perhaps not many minutes, to remove the last trace of vegetation. This illustration furnishes a clue to the method by which the erosion of solid rock in a stream’s bed is effected.

It has been seen that the ingathering waters which make a stream often have abundant sediment before they reach well-defined stream channels, and that the streams continue to gather sediment whereever their beds are composed of material which is readily detached. The sediments which the stream carries are the tools with which it works. Without them it is relatively impotent, so far as the abrasion of solid rock is concerned; with them, it may wear any rock over which it passes ([Fig. 102]).

We have next to inquire the methods by which running water uses its tools in the excavation of valleys. When gravel is rolled along in the channel of a stream there is friction between it and the bed over which it moves. If the pebbles be as hard as the bed over which they are rolled their movement must result in its wear, and even if they be softer more or less wear takes place. As the moving stones wear the rock of the stream’s bed they are themselves worn by impact with it and with one another. In all cases the softer material suffers the more rapid wear. The first effect of wear on materials in transportation is the reduction of their rugosities of surface. The projecting points and sharp angles are worn off, and the stones are reduced to rounded water-worn forms. The particles broken off make grains of sand, or, if very fine, particles of silt or mud. Even after a stone has been rounded it is subject to further wear and reduction, and in the course of time may be literally worn out.

The sediment carried in suspension, as well as that rolled along the bottom, may wear the rock bed of a stream. When a grain of sand in suspension escapes from an upward moving current it may not sink quietly. If it be caught by a downward current it may be made to strike a blow on the bed of the stream, and the effect of the blow is to wear the surface which receives it. The larger the grain and the stronger the current the greater the wear.

Fig. 102.—Some of the tools with which a stream works. The cobbles and bowlders have been shifted by the stream in its flow. Other stones and bowlders now in transit cause the ripples in the stream. The Chelan River, Wash., just above its junction with the Columbia. (Willis, U. S. Geol. Surv.)

The ceaseless repetition of the blows struck by the material in suspension, or rolled on its bottom, hour after hour, day after day, and year after year, will accomplish sensible results. In the long course of the ages this process has excavated deep valleys. Concomitant processes are largely concerned in making valleys wide, but the depth of valleys cut in solid rock is chiefly the result of the impact and friction of the sediment in transportation.

The wear effected in this way is not proportional to the number of blows struck. Since every pebble and every grain of sand carried diminishes the velocity of a stream, and since with diminished velocity the force of the blows struck is diminished, it follows that the blows may become so weak, as the result of their multiplication, as to be ineffective. The larger the load, therefore, which the stream carries, the more the tools with which it has to work, but the less effectively can it use them; and the load may be so far increased as to destroy its corrasive power altogether. On the other hand, the smaller the load of the stream the greater its velocity and the more effectively will its tools be used; but their number may be so far reduced that their aggregate effect is slight. To accomplish the greatest results on a bed of solid rock a stream must have tools to work with, but must not be so heavily burdened as to interfere with its effective use of them.