It will be observed that all glass vessels and tubing are represented in section, and in the thermometers, the fine capillary bores are represented by a single line in each case; corks by diagonal shading; wood by lines in imitation of its grain; metal parts by vertical shading or dead black; more or less still liquids by a series of lines broken below and continuous at the surface, and gradually becoming closer and closer together towards the surface. Mercury, on the other hand, may be indicated by dead black relieved by a few white lines to represent its reflecting surface, also its free surface may be drawn convex. Finally thumb screws may be shewn by a combination of black areas and vertical shading.

These conventionalities need not all be followed; for instance, rubber connexions may be indicated by broad black lines and wood by diagonal shading.

The drawing should be very bold and the different parts clearly and freely indicated by writing or "printing."

THE DRAWING OF MAPS. In the drawing of maps for reproduction by the line block process, if an existing map serves the purpose, a tracing may be made in ink on translucent linen. If, on the other hand, the author has to make his own map, the problem becomes more difficult.

For the obtaining of the data for map making information must be sought for elsewhere, since we are only concerned in the preparation of the map for publication. And as regards this, but few general rules can be laid down since the character of maps is so diverse.

The amount of detail in the physical features represented depends to a great extent upon the scale. Thus streams of a greater breadth than, say, 10 feet, may in large scale maps be represented by double lines, whilst no stream less than 2 feet in breadth will be shewn in low scale maps.

Fig. 36

These three figures illustratein three different ways thevarying levels of a pieceof ground surveyed by Prof.F. W. Oliver and Mr. A. G.Tansley.

The indication of hills is always a problem; the most satisfactory way is by the drawing of contours (Figure 36a), and this whenever possible should be followed, since it is scientifically the most correct method, inasmuch as when properly drawn the form of the hill is shewn exactly; further, contours obscure the detail to a much less extent than does shading, and but little artistic talent is required to draw them. If, however, contouring be impossible, the various heights above the datum may be shewn by spot levels (Figure 36b) or the relative levels may be shewn by layers; that is to say, by a system of shading each kind of which indicates a certain level. Thus dots may be used for all parts not more than 100 feet above sea level, vertical lines for regions between 100 and 200 feet, horizontal lines for parts between 200 and 300 feet, and so on (Figure 36c). It is obvious that this method cannot be pursued if vegetation also is to be shewn. The last choice is to represent the hill by shading in much the same way as many of us did when children; the method referred to was known as "herring bones" or "hairy caterpillars."