Fig. 52.
105. To File Thin Metal Strips. Fig. 52. When sheet-metal is punched by the methods usually employed by boys, a bulge or bur is made on the underside around the hole. If this bur be hammered to flatten it, the hole is distorted and made smaller. It is better to file the bur down, at least part way. It is not convenient to file a piece of thin metal when it is held in a vise. It is better to use either a metal or a wooden clamp, as shown in Fig. 52; then the filing can be quickly and easily done. Y is the yoke to be filed. It is well to place a piece of metal, I, between the table and the end of the screw.
106. Clamp. Fig. 53. If you have no clamp to hold metal strips while filing them, you can put a screw, S, through one hole to hold the strip down fairly tight. Drive a nail, N, behind the strip. This will keep it from turning while you file the free end.
Fig. 53.