Manual of American grape-growing

by U. P. Hedrick

"It consists essentially of the use of a short piece of galvanized iron wire inserted in the pith of stock and scion for the purpose of holding them together, thus replacing both tongues and raffia. It has been objected that the iron would have a deleterious effect on the tissues of the graft, corroding them, or causing them to decay. There seems, however, no reason to expect any such result, and vines grafted in this way have been bearing for years without showing any such effect.

"The preparation and grading of stocks and scions are exactly the same for this method as for the tongue graft.

"Stock and scion are cut at an angle of 45 degrees. A piece of galvanized iron wire two inches long is then pushed one inch into the firmest pith. This will usually be the pith of the stock, but it will depend on the varieties being grafted. The scion is then pushed on to the wire and pressed down until it is in contact with the stock. If the cuttings have large pith it is better to use two pieces of wire, one placed in the stock first and the other in the scion.

"The length of wire to use will vary with the size and firmness of the cuttings, but 2 inches will usually be found most satisfactory. Wire of No. 17 gauge is the most useful size."

Making bundles.

"If the grafts are to be planted out directly in the nursery, they may be simply laid in boxes or trays, covered with damp sacks, and carried out to be planted as soon as made. It is usually better, however, to place them for several weeks in a callusing bed before planting. In this case it is necessary for convenience of handling to tie them up into bundles. No more than twenty grafts should be placed in a bundle, and ten is better. If the bundles are too large there is danger of the grafts in the middle becoming moldy or dry.

"A stand is very convenient. It consists of a piece of board 12 inches, on one end of which is nailed a cleat 6 inches by 4 inches and under the other end a support of the same size. Two 4-inch wire nails are driven through the board from below, 4 inches apart and 5 inches from the cleat. Two other 4-inch nails are driven similarly at 11/2 inches from the other end. The grafts are laid on this stand with the scions resting against the cleat, and are then tied with the two pieces of bluestoned raffia that have previously been placed above each pair of nails. This arrangement insures all the scions, and therefore the unions, being at the same level, and puts both ties below the union where they will not strain the graft. The tying is more expeditious and less liable to disturb the unions than if the bundles are made without a guide.

"A skillful grafter will make about one hundred tongue grafts on cuttings per hour, or from sixty-five to seventy-five per hour if he does the tying as well. Wire grafts can be made at the rate of two hundred and fifty or more per hour, and by proper division of labor where several grafters are employed this number can be easily exceeded. These estimates do not include the preparation and grading of the cuttings."

Grafting rooted cuttings.

The cion may be grafted on a stock rooted in the nursery the previous season, much the same methods being used as with cuttings. This method is employed to utilize cuttings too small to graft, the added sizes attained in the nursery making them large enough, and in grafting on stocks which root with difficulty, thus saving the making of grafts which never grow. The stocks, in this method, are cut so that the cions may be inserted as the original cutting and not as the new growth. The roots, for convenience in handling, are cut back to an inch or thereabouts in length.