When prepared, word is sent to the casemate operator, who tests as follows: He closes switch No. 7 up. This throws D. C. power on the mil-ammeter plug of the operating board and introduces in the circuit the mil-ammeter and its protective lamp. The green lamp is then unscrewed and the mil-ammeter plug used on the D. C. jaw.
If there be no leak in the multiple cable, since the ends at the distribution box boat are held in the air, there will be no appreciable reading of the mil-ammeter.
If there be a leak, this fact will be revealed by a reading on the mil-ammeter. To discover the particular conductor or conductors on which this leak exists, each power switch is opened in succession and the mil-ammeter plug inserted on the jaw of the power switch.
No. 19 is now tested in the same way by first shifting both telephones to No. 1, the boat end being held in the air. The operator reports the result of the test.
Upon completion of these tests the power is turned off. Post power should not be used for testing, because the negative side of the post power may be grounded.
Marking out the mine field.—In using automatic anchors it is not necessary to mark the mine field; but in using mushroom anchors it is generally done. The material required consists of 1 measuring line with reel and frame, 5 anchors, 5 keg buoys, and 5 raising ropes.
A buoyed anchor is dropped about 350 feet in front of the distribution box buoy. This marks the position of mine No. 10 and of the center of the group.
This marking buoy is picked up by a launch which makes fast to the anchor rope. The planter now passes to the launch one end of a measuring line, which has marks at 280, 300, 350, 580, and 600 feet. These marks may be made by painting 3 feet of the measuring line some distinctive color at the designated points. The planter moves out slowly along the line to be occupied by the mines, unreeling the measuring line as it goes, and drops buoys at the 300 and 600 foot marks. It then returns and does the same for the other side of the line. These five buoys mark the line to be occupied by the mines, indicate the positions of mines Nos. 4, 7, 10, 13, and 16, and in addition cut up the distance into 300-foot lengths, which enable the planter to plant mines at a close approximation to 100 feet apart.
Taking soundings on line of mines.—When automatic anchors are used, such information as may be required about depth of water may usually be obtained from charts. This may not be sufficiently accurate for planting with ordinary anchors. In the latter case soundings must be taken at the spots where the mines are to be planted.
These soundings are made from the launches. The launches take a measuring line marked at every 100 feet, stretch it between the planted buoys, and take the soundings at every 100-foot point. The soundings are recorded in a blank book showing the number of the corresponding mine and state of the tide. It may be found more satisfactory to hold one end of the measuring line at the buoy and circle across the line of mines with the launch, getting the sounding at the point of crossing.