RA PD 310242
Figure 45—Removing Fuel Strainer
(2) To install carburetor on manifold, locate carburetor flange and two gaskets (½–inch steel spacer and gaskets if originally fitted) to aline with holes in manifold flange, and insert and securely tighten the three carburetor mounting screws. Use a 7⁄16–inch socket wrench, or a large screwdriver, to securely tighten these screws. NOTE: If carburetor manifold is loose in manifold packing nuts (carburetor can be lifted and manifold turns in packing nuts), tighten manifold nuts securely, using manifold wrench (41–W–1570–10).
(3) Insert carburetor air intake fitting into end of air hose and mount fitting on carburetor with the four screws. Tighten air hose clamp.
(4) Connect fuel pipe to fuel strainer nipple by tightening the union nut and also the strainer union nut on bowl nipple.
(5) Attach throttle control wire to throttle lever connector block and adjust (par. [69]).
(6) Open fuel supply valve and observe for leaks.
(7) Adjust carburetor (par. [68]).
72. FUEL STRAINER ([fig. 45]).
a. Cleaning.