a. Generator is gear driven through engine timing gear train. Generator can be removed and installed without removing timing gear case cover, or affecting alinement of timing gears.
b. Before replacing generator because of failure of instrument panel green signal light to indicate charge, check panel light wiring and bulb for good condition (par. [120]).
c. When it has been determined that generator must be removed for replacement, proceed as follows:
(1) Disconnect wires from the two generator terminals marked SWITCH and RELAY.
(2) Remove the two long screws, through timing gear case cover, that secure end of generator against gear case ([fig. 58]).
(3) Remove strap nut, lock washer, and curved washer from end of strap that clamps generator in its cradle on engine crankcase ([fig. 59]).
RA PD 310261
Figure 58—Removing Generator End Mounting Screws