(3) Tighten the two cap screws securing caution plate and tank top strip.
(4) Connect oil feed pipe to tank nipple. Tank nipple is located at lower rear end of tank.
(5) Connect scavenger (return) pipe to tank nipple. Nipple is located underneath tank, near center.
(6) Connect breather pipe with banjo‐type fitting to tank. Use hollow bolt, making sure flat washers are in place on both sides of banjo fitting and that mounting bolt is tight.
(7) Install instrument panel cover (par. [119]).
(8) See that oil tank drain plug and washer are in place, and that the plug is tight.
(9) Connect battery negative ground wire to frame connection.
(10) After filling oil tank, check all pipe fittings for leaks.
108. STANDS.
a. Remove Rear Stand. Remove nuts which secure rear stand mounting bolts. Drift bolts out of frame clip holes, freeing stand.