(3) Remove the three filler plugs. Check and or adjust electrolyte level. See that electrolyte level is 5⁄16 inch above plates. If necessary, bring electrolyte to that level, using clean, drinkable water.
(4) Clean top of battery before installing box cover.
(5) Clean terminals or posts, if corroded. Make sure that the felt washers are on posts and are saturated with engine oil.
c. Remove Battery. Raise saddle and bar assembly. Release and remove swivel pin. Loosen wing thumb nuts on box top hold‐down studs sufficiently to disengage bracket slots, then lift off box cover. Disconnect positive and negative wires from battery terminals. Lift battery upward out of battery box.
RA PD 310278
Figure 73—Complete Wiring Diagram
1. SWITCH TERMINAL (Three Wires connected)—Black wire from blackout marker light 24; taillight cable green wire from blackout taillight 22; single wire direct from blackout headlight as shown by dotted line in illustration 43, or horn and headlight cable black wire from junction terminal 35 as shown in illustration 44.