(6) Disconnect oil pipe from tank and install nipple cap on oil tank feed pipe nipple to prevent oil from running out, or drain tank. Disconnect pipe from oil pump and remove oil pipe.
(7) Disconnect spark control wire at circuit breaker lever, and free control housing clamp at cylinder base.
(8) Disconnect brake rear rod from bell crank.
(9) Disconnect red wire and black wire from front end of relay; also green wire from generator terminal.
(10) Remove spark plugs.
(11) Remove engine top mounting (cylinder head bracket) bracket to frame lug bolt: this also frees front spark plug cable clamp. Pay particular attention to shim washers (if any) between cylinder head bracket and frame lug; these will have to be installed in the original position.
(12) Remove lever bottom bolt, freeing gear shifter lever from shifter rod.
