(4) Engage remaining steel disk with shell splines with “OUT” side facing outward.
(5) Install “sprung” (one side lined) steel disk, lined side inward, on clutch hub studs.
(6) It will be noted that the three long, threaded‐end, clutch hub studs are not spaced an equal distance apart. It will also be noted that the three holes (keyhole shaped) in the spring collar are not spaced equidistantly. Therefore, when installing releasing disk and spring assembly on clutch hub studs, the three threaded studs and holes in spring collar must be alined. Install assembly on studs, replace the three nut locks, replace the three adjusting nuts, and tighten all three evenly until the distance between shoulder of spring collar and face of releasing disk is 1–1/32 inch ([fig. 27]).
(7) Remove the large washer and replace push rod adjusting screw lock nut. Do not attempt adjustment of clutch release lever and push rod adjusting screw until outer front chain guard and footboard have been installed.
RA PD 315719
Figure 31—Removing Clutch Releasing Bearing Assembly
(8) Install outer front chain guard (par. [102]).