(12) Remove gear shifter rod by disconnecting at hand shifter lever and at transmission gear shifter lever.
(13) Remove the three transmission mounting stud nuts, then remove lock washers and large plain washers (located under frame bracket), and lift transmission sufficiently to permit removal of front chain adjusting screw.
(14) Loosen upper U‐bolts on ignition coil mounting, then remove the lower U‐bolt nuts and shift coil on frame tube as far as possible toward the front.
(15) Remove transmission and clutch assembly from vehicle by lifting complete unit sufficiently to free mounting studs from frame bracket; then rotate top of transmission backward about ¼ turn ([fig. 34]) and remove unit from left side of frame ([fig. 35]).
58. INSTALL TRANSMISSION (figs. [34] and [35]).
a. Install from Left Side. Working from left side of frame, tilt top of transmission backward, and as unit passes into position, rotate top forward, until unit is squarely in position and mounting studs pass through slots in frame mounting bracket.
(1) Shift ignition coil mounting back into correct position and tighten U‐bolt nuts.
