The syphon B is a bent tube, having one leg shorter than the other. It acts by the pressure of the atmosphere. In order to make a syphon act, it is necessary first to fill both legs quite full of the fluid; and then the shorter leg must be placed in the vessel to be emptied. Immediately upon withdrawing the finger from the longer leg, the liquor will flow. Any young person may form a syphon by a small piece of leaden pipe, bent into the form above.

THE PUMP.

The action of the common pump is as follows: When the handle A is raised, the piston-rod B descends, and brings the piston-valve, called the sucker, or bucket, to another valve, C, which is fixed, and opens inwards towards the piston. When the handle is drawn down, the piston is raised, and, as it is air-tight, a vacuum is produced between the two valves; the air in the barrel of the pump, betwixt the lower valve and the water, then forces open the lower valve, and rushes through to fill up this vacuum; and the air in the pump being less dense than the external atmosphere, the water is forced a short way up the barrel. When the piston again descends to the lower valve, the air between them is again forced out by forcing open the upper valve; and when the piston is raised, a vacuum is again produced, and the air below the lower valve rushes up, and the water in consequence is again raised a little further. This operation continues until the water rises above the lower valve; at every stroke afterwards, the water passes through the valve of the descending piston, and is raised by it, on its ascent, until it issues out of the spout.

THE HYDRAULIC DANCER.

Make a little figure of cork, in the shape of a dancing mountebank, sailor, &c. In this figure place a small hollow cone, made of thin leaf brass. When this figure is placed upon any jet d’eau, such as that of the fountain recommended to be constructed, it will be suspended on the top of the water, and perform a great variety of amusing motions. If a hollow ball of very thin copper, of an inch in diameter, be placed on a similar jet, it will remain suspended, turning round and spreading the water all about it.

THE WATER SNAIL, OR ARCHIMEDEAN SCREW,

may easily be constructed. Purchase a yard of small leaden pipe, and twist it round a pole, as in the following figure, A; place a handle at its upper end, B, and let its lower end rest in the water. Between the last turn of the pipe and the orifice place a paddle-wheel, C. Now, should the water be that of a running stream, the force of the stream will turn the pipe, and the water will rise in it till it empties itself into the trough at D. Should the water have no motion, the turning of the handle at B will elevate the water from the lower to the higher level.