The figure of a swan should be cut in cork, and within its beak a small strongly magnetised piece of steel should be placed. The swan should then be covered with a coating of white wax, and fashioned further into the shape of a swan, and glass beads may be placed in its head for eyes. This should be placed in a small tub or large basin of water, and to make it swim about, you should place in a white stick about nine inches long a magnetic bar, on which the north and south poles are marked. If you wish to bring the swan towards you, present to him the north pole of the wand, if you wish it to retire, present the south pole, and thus you may direct the swan to any part you desire.
TO SUSPEND A NEEDLE IN THE AIR BY MAGNETISM.
Place a magnet on a stand to raise it a little above the table; then bring a small sewing-needle containing a thread, within a little of the magnet, keeping hold of the thread to prevent the needle from attaching itself to the magnet. The needle in endeavouring to fly to the magnet, and being prevented by the thread, will remain curiously suspended in the air, reminding us of the fable of Mahomed’s coffin.
TO MAKE ARTIFICIAL MAGNETS WITHOUT THE AID EITHER OF NATURAL LOADSTONES OR ARTIFICIAL MAGNETS.
Take an iron poker and tongs, or two bars of iron, the larger and the older the better, and fixing the poker upright, hold to it with the left hand near the top P by a silk thread, a bar of soft steel about three inches long, one fourth of an inch broad, and one twentieth thick; mark one end, and let this end be downwards. Then grasping the tongs T with the right hand a little below the middle, and keeping them nearly in a vertical line, let the bar B be rubbed with the lower end L of the tongs, from the marked end of the bar to its upper end about ten times of each side of it. By this means the bar B will receive as much magnetism as will enable it to lift a small key at the marked end; and this end of the bar being suspended by its middle, or made to rest on a joint, will turn to the north, and is called its north pole, the unmarked end being the south pole. This is the method recommended by Mr. Caxton, in his process, which he regarded superior to those in former use, and of which a more detailed account will be found in his interesting volume.
HORSE-SHOE MAGNETS.
The form of a horse-shoe is generally given to magnetised bars, when both poles are wanted to act together, which frequently happens in various experiments, such as for lifting weights by the force of magnetic attraction, and for magnetising steel bars by the process of double touch, for which they are exceedingly convenient. The following is the method of making a powerful magnetic battery of the horse-shoe form. Twelve bars or plates of steel are to be taken, and having been previously bent to the required form, that is, the horse-shoe shape, they are then bound together by means of rivets at their ends; before being finally fastened they are each separately magnetised, and afterwards finally united.
Horse-shoe magnets should have a short bar of soft iron adapted to connect the two poles, and should never be laid by without such a piece of iron adhering to them. Bar magnets should be kept in pairs with their poles turned in contrary directions, and they should be kept from rust. Both kinds of magnets have their power not only preserved but increased, by keeping them surrounded with a mass of dry filings of soft iron, each particle of which will re-act by its induced magnetism upon the point of the magnet to which it adheres, and maintain in that point its primitive magnetic state.