Every Boy's Book: A Complete Encyclopædia of Sports and Amusements

by Unknown

The dividing-board being thus completed, mark the place where the wire c is to come through the roof, and bore a hole about half as large again as the wire, so as to allow it to play freely. By the simple plan of making a large nail or waste bit of wire red hot, and charring this hole, the swelling by damp and consequent sticking of the wire will be prevented.

All being ready, slip the dividing-board into the box, taking care to insinuate the wire into its proper place, get it quite upright and square, make sure that the sliding door plays without hitching, and then nail it all tight. Bend the top of the wire into a loop, and the most troublesome part of the business is over. The young carpenter must remember that the dividing-board, with its sliding door, must be made and fixed before anything else is done, as it not only strengthens the box and keeps it in shape, but would demand twice as much trouble after the door and front have been made.

We now come to an easier and more ornamental part of the work.

In the [engraving] both doors open from the front, the one being wired and the other plain wood; but it is best to have the larger door open from behind, as the wire-work is then twice as strong, and all the trouble of making a hinged frame is dispensed with.

Put the box on the ground, and draw a line from one end to the other, just half an inch from the edge. Mark the line off in half-inches, and bore holes quite through the wood, one hole coming at every half-inch. Repeat the same process immediately below, but be careful only to bore the holes half through the wood, or the wire will of course fall through.

Then cut your wire into lengths, measuring them by the depth of the box, and cutting them about one-third of an inch shorter than the total depth. Laying them against the end is a simple method of getting the precise length. Sharpen one end of each piece of wire, push the sharpened end through the hole at the top, draw the wire down, insinuate the point into the hole below, and then, holding the middle of the wire with the fingers of the left hand, in order to keep it from bending, drive it down with the hammer until quite level with the top of the box. When all the wires are thus driven home, nail a strip of wood over them at the top, and they can never come out again.

It will be better to strengthen it further by passing a similar wire horizontally across the others, driving each end into the wood, and binding all together with fine wire. This will be a protection through which not even a rat could crawl, and which no cat could tear away with her hooked claws.

The door of the sleeping apartment is easily made of a single piece of board, cut to the requisite shape, affixed by leathern or metal hinges, and fastened by a simple hasp. The door of the day-room is made in a similar manner, but opens from behind. A row of deep notches should be cut at the bottom of this door, and corresponding holes bored through the back of the sleeping-room floor, in order to let all the wet drain away and keep the rabbit dry. The hutch should be made to slant a little backwards so as to aid in the drainage.

Slate floors have been suggested, in order to prevent the ill-drained moisture from soaking into the substance—a result which is sure to take place, sooner or later, with a wooden floor. Slate, however, is rather expensive, but it is easily cleaned, and can be thoroughly washed; so that the suggestion is worthy of notice.