Fig. 9.—Withe in Place.
A fence which is cheaply constructed in a timbered region, and calls for no outlay whatever, besides labor, is illustrated at [figure 7]. The posts are set in a straight line, having previously been bored with an inch augur to receive the pins. When they are set, the pins are driven diagonally into the posts, and the poles laid in place. It would add much to its strength, if the poles were laid so as to “break joints.” A modification of this fence is sometimes made by using withes instead of pins to hold the poles in place. The withe is made of a young sapling or slender limb of beech, iron-wood, or similar tough fibrous wood, with the twigs left on. This is twisted upon itself, a strong loop made at the top, through which the butt is slipped. When in place, the butt end is tucked under the body of the withe.
FENCES FOR SOIL LIABLE TO HEAVE.
Fig. 10.—End View Of Fence.
Fig. 11.—Side View Of Fence.
The main point in such a fence is either to set the posts and place a pin through them near the bottom, so that the frost may not throw them out, or to so attach the boards that the posts may be re-driven, without splitting them, or removing the rails from the fence. The latter is, perhaps, the best plan, and may be accomplished in several ways, the most desirable of which is shown in [figures 10] and [11]. The post, h, is driven in the usual manner, when a strip of board, g, is fastened to it by three or four spikes, depending upon the hight of the fence. A space just sufficient to insert the ends of boards a, e, [figure 11], is left between the post and outside strip, the ends of the boards resting upon the spikes. Many miles of this fence are in use. It looks neat; besides any portion is easily removed, making a passage to and from the field. A new post is easily put in when required, and any may be re-driven when heaved by the frost.
