XIII. To Remove Top Carriage.
1. Remove spring cylinder (see X) rocker and rocker arms (see XII).
2. Remove angle of site bracket, left, by removing three split pins and nuts from ⅜” bolts in angle of site bracket cover, left, taking off cover, removing nut and split pin from traversing handwheel shaft, removing handwheel and drawing shaft out to the left.
3. Remove two split pins and ¼” nuts from cross shaft pinion case (left) bolts, extract bolts, and remove case.
4. Remove cross shaft pinion case, right, as in XIII-3.
5. Remove split pins and two nuts from cross shafts, right and left.
6. Remove split pins and nuts from four ½” studs securing angle of site bracket, left, and remove bracket with attached parts as a unit.
7. Remove angle of site bracket, right, as in XII-5.
8. Draw out cross shafts, right and left, and remove cross shaft pinions, right and left.
9. Traverse top carriage to the right (by turning intermediate shaft gear by hand) sufficiently to allow traversing stop, rear to be removed. Extract split pin, remove nut, and take off traversing stop, rear.