Fig. 91
75. Cremorne Bolts.—In the best work, the Cremorne bolt is used for casement windows. This device consists of a vertical rod divided at or about the middle of its length, thus making two pieces, and is operated by a knob, or handle, at that point. Types of ornamental Cremorne bolts are illustrated in [Fig. 92]. As shown, the upper and lower ends of the rods, or bolts, slide vertically and in opposite directions, being operated by the turning of the knob, or handle. These bolts are furnished with suitable strikes, either of the plate or the box form, which are attached to the window at the top or the bottom. Since the ends of the bolts are beveled, they press the two sashes tightly together and against the sash frame when they are thrown in. A single movement of the knob, or lever handle, is sufficient to release both bolts.
Fig. 92
76. Espagnolette Bolts.—In [Fig. 93] is shown the Espagnolette bolt, which is similar in construction to the Cremorne bolt. This bolt consists of a vertical rod, but instead of being in two pieces, as in the Cremorne bolt, it is in one piece. This rod has hooks at each end, and, by a rotary motion, engages pins, or plates, in the window frame and thus draws the sashes together and against the frame. These bolts are usually operated by a pendant handle, which, when lifted to a horizontal position, will release the rod so that it may be rotated to fasten or to release the sash. For very high sash, a supplemental design may be used by providing a tapered hook on the opposite sash for the pendant. The Espagnolette bolt is usually heavier than the Cremorne and exerts more power in forcing the sashes against the frame; it is also more expensive. Both bolts, however, are available for use on doors as well as on windows, and lend themselves admirably to decorative treatment, as shown in the illustrations.
Fig. 93
The same care should be exercised in the selection of these bolts as for other hardware, and when ordering them, full-sized details should accompany the order, showing sections through the top rail and head-jamb, the bottom rail, the sill, and the lock stile. The exact measurement of the height and the width of the openings should also be given, and the information should state whether the sash swings inwards or outwards. The hand of the active leaf, as well as the height of the handle from the floor, should also be given. In [Fig. 94] are shown sections through a casement sash, illustrating the conditions requiring the use of Espagnolette bolts, and, as just stated, sections similar to these should be furnished the dealer, or manufacturer, so that these bolts will fit the construction when they are delivered.
