Such a filter should be cleansed at least twice in a year by pumping out all the water, taking out the mud or settlings, and one-half the depth of the top layer, and replacing with fresh sand.
The double filter cistern, Fig. 18, has much to recommend it, having a large receiving basin which in itself is a filter placed in a position for easy cleaning. The recess at the bottom may be covered with a perforated plate of galvanised sheet iron, upon which may be laid a filter bed of gravel, sand, charcoal, spongy iron, and sand in the proportions as stated above. This enables the frequent cleaning by removing the top layer of the filter bed without disturbing the water supply. The cover should fit tight enough to keep out insects and vermin.
A double-bottomed basin perforated and filled with clear, sharp sand and charcoal should be attached to the bottom of the pump pipe, as shown.
This enables the small filter to be drawn up and cleaned, without the necessity of emptying the cistern or interrupting the water supply.
18. Filter Cistern. 19. Keg Filter.
The half barrel or keg filter, as illustrated in Fig. 19, is a convenient form of cistern filter where filtered water is required from cisterns already filled.
This is also a convenient form for readily cleaning or changing the filter without the necessity of discharging the water from the cistern.
This filter can be made from an oak keg or half barrel, such as is used for liquors or beer. Take out one of the heads and cut away the edge, so that it will just drive into the end of the keg, fasten 2 battens of oak across the head with oak pins left long enough to serve for legs for the filter to rest upon.
Bore this head full of holes ¼ in. diameter. In the other head bore a hole 1¼ in. diameter, and bolt an iron flange into which the pump pipe is to be screwed. Let the bolts also fasten upon the inside a raised disc of galvanised sheet iron, perforated with a sharp point or chisel. Proceed to charge the filter by turning the top or flanged head down, and placing next the perforated plate a layer of fine gravel 3 in. thick, then a layer of sharp, clean sand 3 in. thick, then a layer of pulverised charcoal free from dust, 3 in. thick, then a layer of sharp clean sand mixed with spongy iron, pulverised magnetic iron ore, or blacksmiths’ scales, followed by a layer of coarse sand, gravel, and broken stone, or hard burnt bricks broken into chips to fill up. Place the perforated bottom in as far as the head was originally; bore and drive a half-dozen oak pegs around the chine to fasten the head. Then turn over the filter, screw the pump pipe into the flange, and let it down into the cistern.