Another type of foot rest with a slanting top is shown in [Fig. 14]. The framework is built up of dowels, straight sections only being used. The joints are fastened by the method used in the first and second models described. The method of covering the frame is essentially the same as for the stool shown in [Fig. 15], or an adaptation of that used in [Fig. 11] may also be applied. Where facilities for steaming or moistening the dowels are not to be had conveniently, this type of construction will be found satisfactory, the designs being limited to straight lines, however. The method of covering the framework used in [Fig. 3] is also available for the framework shown in [Fig. 4], and the corners may be finished as shown in [Fig. 2]. Numerous variations and combinations of the types shown may be worked out readily after one has become reasonably familiar with the possibilities of woven-reed construction.
Squirrel-Skin Bill Fold
Bill Fold Fashioned from a Squirrel Skin as a Souvenir of a Hunting Trip
As a souvenir of the “days afield” my brother fashioned a quaint bill fold out of a squirrel skin, which, by the way, is a skin of remarkable toughness, After tanning the skin and removing the hair, it was cut as shown, the skin of the forelegs being used as fold-overs. The piece of tape took the place of the tail. The shot holes through the skin added the requisite touch of realism, recalling a day with the gun.—James M. Kane, Doylestown, Pa.
Waterproof Dry-Battery Case
Batteries Protected by a Waterproof Case will Give Longer and More Efficient Service
Dry batteries that are sealed in a tight, waterproof case will last much longer than those exposed to dampness, especially in marine practice. A box, like that shown in the sketch, will afford excellent protection and add materially to the life and efficiency of batteries. It is constructed of ¹⁄₂-in. cypress, or oak, of a length and width depending upon the capacity in number of cells desired. The inside dimensions should be such that the cells are firmly fitted. It should be put together with screws and marine, or any other waterproof, glue. The batteries should be placed in the case and connected. Molten paraffin wax should then be poured over and under the cells. Do not get the wax too hot, but heated only to the melting point. Binding posts and a single-blade switch should be placed on the case and connected up. Screw on the cover, after painting the top edges with the glue. Give the case a good coat of varnish and paint, and fit with a carrying handle. This makes a neat and handy battery outfit that is thoroughly waterproof. The case can be refilled by cutting out the wax and removing the old cells.—B. F. Dashiell, Baltimore, Md.